Heatfab Saf-T Liner 316 4619SS handleiding

Niet gecategoriseerd

Heatfab

8 pagina's

PDF beschikbaar

Handleiding

CHIMNEY MAINTENANCE

The chimney connector and Saf-T Liner should be inspected frequently

during the heating season and cleaned annually (more often if necessary)

by a professional, certified chimney sweep. Formation of creosote and

soot and the need for removal occurs when wood is burned slowly,

producing tar and other organic vapors, which combine with expelled

moisture to form creosote. The creosote vapors condense in the relatively

cool flue of a slow burning fire. As a result, creosote residue accumulates

on the flue lining. If ignited, this can make an extremely hot chimney fire.

The chimney should be inspected at least every 6 to 8 weeks during the

woodburning season to determine if a creosote or soot buildup has

occured. To inspect and/or clean the chimney, loosen the four Tek screws

with a nutdriver and remove the rain cap. If creosote or soot have

accumulated, have the chimney professionally cleaned to reduce the risk

of a chimney fire.

A round-wire steel or Poly chimney cleaning brush is recommended to

clean the Saf-T Liner. Heat-Fab does not recommend the use of chemical

chimney cleaners which may be harmful to the Saf-T Liner. After thor-

oughly cleaning the chimney re-install the rain cap by using the four Tek

screws.

WARNING! Do not use any loose fill, cementious, or

blanket insulation thicker than 1/4 inch equivalent

refractory ceramic fiber. These products void the

Saf-T Liner and may create unsafe conditions

resulting in damage to the masonry chimney and/or

the liner system.

Rain Cap

Storm Collar

Cover Plate

Saf-T Liner

Saf-T Wrap

Appliance Tee

Clean Out Tee

Tee Cover

Fig. 7

Fill

Saf-T Liner Stainless Steel Chimney Liner

Limited Warranty

Heat-Fab, Inc. warrants to the original consumer purchaser that the Type 304 Saf-T Liner will be free from defects in material

or manufacturer’s workmanship when properly installed with Saf-T Wrap insulation pursuant to these manufacturer’s

installation instructions and according to the local building codes, when used under normal conditions as connector pipe or

chimney relining material for Wood Burning residential appliances Tested and Listed by a recognized laboratory, or site build

masonry fireplaces and when inspected and cleaned by a certified professional at the consumer’s expense at intervals of no

more than twelve (12) months, commencing from the date of purchase, as verified below.Type 316 Saf-T Liner will be free from

these same defects when connected to coal burning appliances for a period of 10 years.

In order to obtain warranty service, the consumer must give prompt written notice of any defect to Heat-Fab, Inc. at it's current

address or via e-mail to mail@heat-fab.com. The sole responsibility of Heat-Fab, Inc. shall be to replace those lengths of

liner found to be defective upon return F.O.B. to the Heat-Fab factory. Heat-Fab, Inc. shall not be responsible for the cost

of removing or installing the lengths which are subject hereto, nor shall it be liable for any special, incidental or consequential

damages or expenses incurred by the consumer.

This warranty gives the consumer specific legal rights, in addition to any other rights which may pertain, which vary from state

to state.

Bekijk gratis de handleiding van Heatfab Saf-T Liner 316 4619SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.