Haws 1211SFH handleiding
Handleiding
Je bekijkt pagina 6 van 21
9/21 1200 S
eries Electric Water Coolers Page 6 of 21
F. OPTIONAL DEACTIVATION OF THE BUBBLER(S) (BOTTLE FILLER MODELS
ONLY)
F.1.
DEACTIVATION OF THE BUBBLER(
S)
1. Remove the clear plastic cover underneath the bowl on the right side or
single unit by using a T20 torx bit.
2. Locate the component on the circuit board that has eight numbered
switches. It is adjacent to the blue button. Using a
nonmetallic pointed
object such as a mechanical pencil tip, change the position of switch 1 to
the “ON” p
osition by sliding it up. Switch 1 is on the left, closest to t
he
blue button.
3.
Verify that the bubbler(s) have be
en deactivated by pressing the pushbar
or
putting a hand in front of the sensor (if applicable). The bottle filler
display should be displaying a “fountain off” messa
ge every ten seconds.
4.
Reinstall the clea
r plastic cover.
F.2. INSTALL
ATION OF THE COVER PLATE(
S) –
OPTI
ONAL BUT HIGHLY RECOMMENDED
5. Disconnect power to the unit via the breaker or by removing the skirt and unplugging the main power cord.
6.
Remove the black plastic cover underneath the bowl by removing the (4) screws usi
ng either a phillips bit or 5/16” nut
driver.
7.
Remove the (3) T20 head screws attaching the bubbler to the bowl, then pull up on the bubbler to release the push-to-
connect fitting from it.
8.
Store the bubbler and T20 head screws in a safe
location so that they can be reinstalled later.
9.
Install the cover plate by using the (3) Short length T-20 head screws, taking care that the rubber ga
sket is positioned
properly.
10.
Install the push-to-connect fitting that previously connected to the bubbler to the stem which is attached to the cover pla
te.
11.
Reinstall the lower bowl cover with the (4) screws, making sure it is slid to the frontmo
st position before installing the
screws using a low amount of t
orq
ue.
12.
Repeat steps 6-11 for the high (left) side unit if applicable.
13.
Reconnect power to the unit.
Figure 6: Cover Plate Installation
F.
3. REINSTALLATION AND REACTIVATION OF THE BUBBLER
Reverse the steps above, taking care that the power is off while working inside of the bowl area. Flush
water through the bubbler for at least five minutes prior to use.
Figure 4: Access to Switches
Figure 5: Bubbler Removal
Bekijk gratis de handleiding van Haws 1211SFH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haws |
| Model | 1211SFH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3610 MB |
