Handleiding
Je bekijkt pagina 11 van 36
CWBPM-0525
11
English
5. For closed cabinet installations, install the intake air
ducting.
a. Install the intake bracket to the inside of the cabinet over
the 12″x12″ cutout.
Intake
Bracket
Screw
Installing the Intake Bracket
b. Install the flexible duct to the duct collar on the
condensing unit using the duct clamp.
c. Install the duct collar on the other end of the flexible duct
using the duct clamp.
Duct Collar
Duct Clamp
Flexible Duct
Duct Collar
Installing the Flexible Duct
d. Insert the flexible duct into the intake bracket. Bend
the tabs on the duct collar to the outside to secure the
flexible duct.
Intake
Bracket
Duct
Collar
Tabs
Installing the Flexible Duct to the Intake Bracket
6. Clean the well enclosure thoroughly in preparation for
initial operation. Refer to the MAINTENANCE section for
proper cleaning procedures.
NOTE: If a catch pan is used underneath the drain fitting, make
sure the pan is emptied regularly to prevent over-flowing.
7. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See
the SPECIFICATIONS section for details.
Installing the Remote Control Panel
Use the following procedure to install the control panel remotely.
WARNING
Control panel must be mounted in a vertical surface.
Mounting control panel in a horizontal surface may result
in the collection of liquids and lead to electric shock.
1. Cut and drill the appropriate holes in the mounting surface.
Refer to the “Control Panel Cutout and Screw Hole
Dimensions” illustration below for the cutout dimensions.
2. Remove the four trim cover screws from the control panel
and remove the trim cover.
3. Position the control panel into the cutout opening through
the backside.
4. Fasten the control panel to the vertical surface using four
screws (not supplied).
5. Apply a 1/4″ (6 mm) bead of NSF-approved silicone sealant
where the trim cover will contact the cabinet surface. Refer
to the “Control Panel Cutout and Screw Hole Dimensions”
illustration for more information.
6. Reinstall the trim cover on the control panel and secure
in position using the four trim cover screws. Make sure to
embed the trim cover edge into the silicone.
7/16″
(11 mm)
3/8″
(9 mm)
Silicone Sealant
5-5/8″
(143 mm)
7-7/16″
(189 mm)
7-3/4″
(196 mm)
3-1/2″
(89 mm)
1-1/16″
(27 mm)
Control Panel Cutout and Screw Hole Dimensions
NOTE: Make sure the width of the control panel cutout does
not exceed the above dimension.
INSTALLATION
Bekijk gratis de handleiding van Hatco CWBP-4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hatco |
| Model | CWBP-4 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 6069 MB |
