Hanseatic HWMA814A handleiding
Handleiding
Je bekijkt pagina 61 van 89
Set-up, connection and initial start-up Page EN-15
3. Within the following 10 seconds: Touch
and hold the RPM /
button (12) and
end time preset button (10) simultan-
eously for about 3 seconds until the dis-
play (4) shows ‘t19’.
4. Touch the Start/Pause button (8).
– The display shows the spin speed in real
time. When the spin speed reaches a
stable value, the calibration is complete
and the appliance stops operating.
– If instead the display shows “255” or “0”:
The calibration has failed. Check if any
objects are left in the drum and start the
calibration again.
5. After successfully completed calibra-
tion: Switch off the appliance by setting
the programme selector to the OFF po-
sition.
Commissioning and test run
The appliance requires an initial wash cycle
without laundry, but with detergent. The
aim of this is to rinse out possible residues
from production.
1. Fill the main laundry compartment (26)
with a maximum of 25 ml of compact
detergent.
2. Make sure that the drum is empty.
3. Press the appliance door (19) firmly
closed.
4. Proceed as described in the section
"Standard cycles", using the "Cotton"
programme.
First use is completed once the cycle has
finished.
Bekijk gratis de handleiding van Hanseatic HWMA814A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanseatic |
| Model | HWMA814A |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 9146 MB |
