Hanseatic HWMA714ABI handleiding
Handleiding
Je bekijkt pagina 59 van 86
Set-up, connection and initial start-up Page EN-15
3. Within the following 10 seconds: Simul-
taneously touch and hold the buttons
RPM /
(12) and end time preselection
(10) for about 3 seconds until the dis-
play (4) shows "t19".
4. Touch the Start/Pause button (8).
The display shows the spin speed in
real time. When the spin speed reaches
a stable value, the calibration is com-
plete, and the appliance stops operat-
ing.
If the display shows "255" or "0" in-
stead: the calibration has failed. Check
if there are any objects in the drum and
restart the calibration.
5. Once calibration has been successfully
completed, switch off the appliance by
setting the cycle selector to the OFF po-
sition.
Commissioning and test run
The appliance requires an initial wash cycle
without laundry, but with detergent. The
aim of this is to rinse out possible residues
from production.
1. Fill the main laundry compartment (25)
with a maximum of 25 ml of compact
detergent.
2. Make sure that the drum is empty.
3. Press the appliance door (19) firmly
closed.
4. Proceed as described in the section
"Standard cycles", using the "Cotton"
programme.
First use is completed once the cycle has
finished.
Bekijk gratis de handleiding van Hanseatic HWMA714ABI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanseatic |
| Model | HWMA714ABI |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 9670 MB |
