Handleiding
Je bekijkt pagina 46 van 64
Start-upPage EN-14
– from oil and coal burning stoves 30cm
– from other cooling appliances 2 cm
– from washing machines/
dishwashers 2 cm
– If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid material.
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure adequate air circulation,
– the entire space above the appliance
must be clear.
– the appliance should not stand directly
against the wall (leave a minimum clear-
ance of 5 cm)
– the clearance between the ventilation
slots and the wall, units or other appli-
ances must be at least 15 cm.
3. Check the position with a spirit level.
4. Level out any unevenness on the ground
using both of the front screw feet.
– Close the door.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the door.
Cleaning before use
In order to remove the odour which is pres-
ent with all new appliances, wipe the interior
space and the freezer baskets (2) prior to first
use with a water and vinegar solution. Then
wipe it out with clean water and dry all of the
parts off afterwards.
Connecting the appliance to
electricity
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Do not operate or continue to use the
appliance, if it
– shows visible signs of damage, e.g.
the power cord is defective,
– starts smoking or there is a smell of
burning,
– makes unfamiliar noises.
In such cases, pull out the mains
plug or unscrew/isolate the fuse and
contact our service department (see
chapter “Service”).
■ Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■ Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cat-
egory III must be connected within
the house installation with at least
3mm contact clearance; this includes
fuses, circuit breakers and contactors.
■ When positioning the appliance, en-
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges.
Bekijk gratis de handleiding van Hanseatic HGS8555BW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanseatic |
| Model | HGS8555BW |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 6660 MB |
