Handleiding
Je bekijkt pagina 60 van 85
Page EN-16 Fitting and installation
Preparing food
1. Use a jigsaw to cut a hole in the worktop
for the hob. It must have the following di-
mensions.
560 to 564
490 to 494 5050
(Measurements in mm)
2. If a hob was already installed, the cut-out
section must be no larger than:
560 to max. 574 mm wide
490 to max. 494 mm deep.
Attach rails!
574
560
7
7
490
(Measurements in mm)
3. Attach adjustment strips to the left and to
the right of the worktop in order to achieve
the width of 560 mm.
4. Seal the cut surfaces with a special var-
nish, silicone sealant or cast resin to pre-
vent swelling caused by moisture.
Preparing and inserting the hob
NOTICE
Risk of breakage!
■ Do not place the hob on the glass ce-
ramic edge!
1. Take the hob out of the packaging.
2. Remove all protective films and adhesive
tapes.
3. Turn the hob over and place it with the
glass side down on a soft surface.
4. Carefully place the hob (residual heat in-
dicators at the front) in the middle of the
worktop cut-out.
Thin worktop
Bekijk gratis de handleiding van Hanseatic 65C90C7-E11B000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanseatic |
| Model | 65C90C7-E11B000 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 9518 MB |
