Hama 00176668 handleiding
Handleiding
Je bekijkt pagina 8 van 26
7
The following steps are required to commission the device:
• Place the 2 enclosed AAA batteries correctly in the battery compartment provided.
• Put the device in Pairing mode by holding the Reset button down for around 15 seconds. The LED starts
to ash quickly.
• You can secure the smart water sensor contact using the enclosed adhesive pad.
• Be aware that the intended mounting surface must be free from dust and grease. Use a suitable
cleaner from a specialist retailer for this.
• Be aware that the adhesive pads are intended to be permanent. Carefully pull the adhesive pad off
the mounting surface to remove it.
• Various environmental inuences, such as moisture in the air, sunlight, cold, etc., can impair the
long-term stickiness of the adhesive pads.
• Possible residue on the mounting surface after removal of the adhesive pads cannot be ruled out!
Bekijk gratis de handleiding van Hama 00176668, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hama |
| Model | 00176668 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2203 MB |
