Handleiding
Je bekijkt pagina 24 van 56
2424
A
Fig. 3.1
CONNECTION OF THE POWER SUPPLY CABLE
Important! This appliance must be connected to the electricity supply only by an
authorised person.
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
• Unhook the terminal board cover by inserting a screwdriver into the two hooks “A” (g. 3.1).
• Open the cable gland by unscrewing screw “F
”
(g. 3.2), unscrew the terminal screws.
• Insert the feeder cable of the suitable section (as described in the next chapter) into
the cable gland.
• Connect the phase, neutral and earth cables to the terminal block according to the
diagram in gure 3.3.
• Pull the feeder cable and block it with cable gland.
• Close the terminal block cover (check the two hooks “A
”
are correctly hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws xing
the cover plate behind the terminal block.
NOTE: The earth conductor must be left
about 3 cm longer than the others.
FEEDER CABLE SECTION
Type “H05RR-F”
220-240V ac 3 x 1,5 mm
2
(*)
(*) Connection possible with plug and outlet
F
230 V
PE
N
L
Fig. 3.3
Fig. 3.2
220-240V ac
Bekijk gratis de handleiding van Haier HGM95TC1XS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | HGM95TC1XS |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5089 MB |
