Handleiding
Je bekijkt pagina 23 van 80
2323
REPLACEMENT OF THE
INJECTORS OF THE BURNERS
Select the injectors to be replaced
according to the “Table for the choice of the
injectors”.
The nozzle diameters, expressed in
hundredths of a millimetre, are marked on
the body of each injector.
If the injectors are not supplied they can
be obtained from the “Service Centre”.
REPLACEMENT OF THE
INJECTORS OF THE COOKTOP
BURNERS
To replace the injectors proceed as follows:
• Remove pan supports and burners
from the cooktop.
• Using a wrench, substitute the nozzle
injectors “J” (gs. 2.4, 2.5) with those
most suitable for the kind of gas for
which it is to be used.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
ADJUSTING OF THE MINIMUM OF
THE TOP BURNERS
In the minimum position the ame must
have a length of about 4 mm and must
remain lit even with a quick turn from the
maximum position to that of minimum.
The procedure for adjusting the minimum
gas rate setting is described below.
• Light the burner.
• Set the gas valve to the “minimum
rate” position.
• Remove the knob.
• Using a screwdriver turn the screw “A”
until adjustment is correct (g. 2.6).
Normally for LPG (G30/G31), tighten up
the regulation screw.
J
Fig. 2.4
Fig. 2.6
A
Fig. 2.5
J
Auxiliary semi-rapid
and rapid burners
Double-ring compact
Bekijk gratis de handleiding van Haier HGM64TC1XS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | HGM64TC1XS |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 7965 MB |
