Handleiding
Je bekijkt pagina 7 van 28
7
z
Please make this information available to the person responsible for installing the appliance as it could
reduce your installation costs.
z
In order to avoid a hazard, this appliance must be installed according to these instructions for
installation.
z
This appliance should be connected to a circuit which incorporates an isolating switch providing full
disconnection from the power supply.
z
Failure to install the appliance correctly could invalidate any warranty or liability claims.
z
Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding
the hob.
z
Consult local building authorities and by-laws if in doubt regarding installation
z
To avoid any damage, the foam seal and adhesive must be resistant to heat.
Electrical
z
This cooktop must be connected to the mains power supply only by a suitably qualified person.
z
This cooktop must be earthed by a suitably qualified person.
z
A suitable isolating switch providing full disconnection from the mains power supply is incorporated in
the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations.
z
The isolating switch must be of an approved type and provide a 3 mm air gap contact separation
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the
requirements).
z
Before connecting the cooktop to the mains power supply, check that:
z
The domestic wiring system is suitable for the power drawn by the cooktop
z
The voltage corresponds to the value given on the rating plate
z
The power supply cable sections can withstand the load specified on the rating plate.
z
To connect the cooktop to the mains power supply, do not use adapters, reducers, or branching
devices, as they can cause overheating and fire.
z
The power supply cable must not be kinked and should not be touching the underside of the
cooktop which could get hot during operation.
z
If the cable is damaged or needs replacing, this should be done by an after-sales technician using
the proper tools, so as to avoid any accidents.
z
If the appliance is being connected directly to the mains supply, an omni-polar circuit breaker
must be installed with a minimum gap of 3mm between the contacts.
z
The installer must ensure that the correct electrical connection has been made and that it
complies with safety regulations.
z
The cable must be checked regularly and if the supply cord is damaged it must be replaced by a
properly qualified person.
z
The power supply should be connected in compliance with the relevant standard, or a single-pole
circuit breaker. The method of connection is shown below.
Electromagnetic hazards
z
This appliance complies with electromagnetic safety standards.
z
However, persons with cardiac pacemakers or other electrical implants (such as insulin pumps) must
consult with their doctor or implant manufacturer before using this appliance to make sure that their
implants will not be affected by the electromagnetic field.
z
Failure to follow this advice may result in death.
SAFETY AND WARNINGS
Bekijk gratis de handleiding van Haier HCI905MFTB4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | HCI905MFTB4 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 1942 MB |
