Haier FlexFit 4Q36FF2BEA handleiding
Handleiding
Je bekijkt pagina 7 van 118
31-5001082 Rev. 2 7
ENGLISH
IMPORTANT SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS
CAUTION
• Refrigerant should be only added or removed by a licensed HVAC technician.
• Before adding additional refrigerant, perform air purging from the refrigerant pipes and indoor unit using a vacuum
pump,then charge additional refrigerant.
Unpacking Inspection
Outdoor unit: the leak detection equipment shall be extended into the packing box of the outdoor unit, to check whether
the refrigerant is leaking. If the refrigerant leakage is identified, installation is not allowed, and the outdoor unit shall be
delivered to the maintenance department.
Inspection on Installation Environment
1. Inspection on the surrounding environment of place of installation: the outdoor unit of flammable refrigerants air
conditioner cannot be installed inside an enclosed room reserved.
2.
Power supply, switches or other high-temperature articles such as the ignition source and oil heater shall be avoided
below the indoor unit.
3. The power supply shall be provided with grounding wire and be reliably grounded.
4.
User shall verify in advance whether water/electricity/gas pipelines are hidden in the wall in locations that may
be punctured with an electric drill. It is recommended that the through-wall holes reserved shall be used as much as
possible.
Safety Principles of Installation
1. Favorable ventilation shall be maintained at the place of installation (doors and windows are opened).
2.
Open fire or high-temperature heat source (including welding, smoking and oven) higher than 548°F is not allowed within
the scope of flammable refrigerant.
3. Anti-static measures shall be taken, such as the wearing of cotton clothes and cotton gloves.
4.
The place of installation shall be convenient for installation or maintenance and cannot be adjacent to heat source and
flammable and combustible environment.
5.
In case of refrigerant leakage of the indoor unit during installation, the valve of the outdoor unit shall be closed
immediately, and windows shall be opened, and all the personnel shall be evacuated. After the leakage of refrigerant is
handled, the indoor environment shall be subject to concentration detection. Further handling is not allowed until the
safety level is reached.
6.
In case the product is damaged, it must be delivered to the maintenance point. Welding of refrigerant pipelines at the
user’s site is not allowed.
7.
The installation position of air conditioner shall be convenient for installation or maintenance. Barriers shall be avoided
around the air inlet/outlet of the indoor/outdoor unit, and the electrical appliance, power switches, sockets, valuables, and
high-temperature products within the scope of both sidelines of the indoor unit shall
be avoided.
Bekijk gratis de handleiding van Haier FlexFit 4Q36FF2BEA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | FlexFit 4Q36FF2BEA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12094 MB |
