Handleiding
Je bekijkt pagina 4 van 88
4
31-5001099 Rev. 1
READ AND SAVE THESE INSTRUCTIONS
WARNING
- This product is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the product.
- Ensure that the unit shall be installed in accordance with local and national wiring codes.
- For the dimensions of the space necessary for correct installation of the appliance, including the minimum
permissible distances to adjacent structures, refer to this document.
- Ensure only approved units are connected together and that all refrigerant line dimensions and refrigerant charging
requirements are followed to prevent exceeding the maximum operating pressure.
- ONLY connect units that are labeled with the same refrigerant.
- Any damage of electrical supply must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
- Means for disconnection must be incorporated in the fixed wiring in accordance with wiring rules. Disconnect ampere
rating must be at least 115% of the Minimum Circuit Ampacity listed on the rating plate for this product. Disconnect
must be installed within sight and readily accessible. Refer to local and national electric code for any additional
requirements specified in your region of install.
Safety Awareness
1. Procedures: Operation shall be made as per controlled procedures to minimize the probability of risks.
2. Area: Area shall be divided and isolated appropriately, and operation in an enclosed space shall be avoided. Before
the refrigeration system is started or energized, ventilation or opening of the area shall be guaranteed.
3. Site inspection: The refrigerant shall be checked.
4. Fire control: A fire extinguisher and a "No Smoking" sign shall be placed in the installation area during installation.
The installation area shall remain free from fire/ignition sources during installation.
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
For more help, visit geappliancesairandwater.com or call the technical support line at 1.844.487.9443
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for local inspector’s use.
• IMPORTANT – Observe all governing codes and ordinances.
• Note to installer – Be sure to leave these instructions with the Consumer.
• Note to consumer – Keep these instructions for future reference.
• Skill level – A licensed certified technician (to handle refrigerant, recovery, etc) and a qualified electrician are
required for installation and service of this split heat pump system.
• Use team lift for mounting the ducted unit.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under the limited warranty.
• For personal safety, this system must be properly grounded.
• Protective devices (fuses or circuit breakers) acceptable for installation are specified on the nameplate of
each unit.
• Make sure to minimize wiring or plumbing inside the wall when installing.
Bekijk gratis de handleiding van Haier Endure US09CB2BEA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | Endure US09CB2BEA |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 18062 MB |
