Handleiding
Je bekijkt pagina 3 van 88
31-5001099 Rev. 1 3
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
READ AND SAVE THESE INSTRUCTIONS
WARNING
For your safety; the information in this manual must be followed to minimize the risk of fire,
electric shock, or personal injury.
• Use this equipment only for its intended purpose as
described in this manual.
• This heat pump must be properly installed in
accordance with these instructions before it is used.
• All wiring should be rated for the amperage value listed
on the rating plate. Use only copper wiring.
• All electrical work must be completed by a qualified
electrician and completed in accordance with local and
national building codes.
• All air conditioners contain refrigerants, which under
federal and/or local law must be removed prior to
product disposal. If you are getting rid of an old product
with refrigerants, check with the company handling
disposal.
• These R454B heat pumps systems require that
contractors and technicians use tools, equipment and
safety standards approved for use with this refrigerant.
• DO NOT use equipment certified for R22,R32 or R410A
refrigerant only.
WARNING
RISK OF ELECTRIC SHOCK. Could cause injury or death.
• An adequate ground is essential before connecting the
power supply or charging with refrigerant.
• Disconnect all connected electric power supplies before
servicing.
• Aluminum building wiring may present special problems
- consult a qualified electrician.
• The surrounding conditions (ambient temperature, direct
sunlight, and rainwater) shall be noticed during electrical
wiring, with effective protective measures being taken.
• The dedicated branch circuit must be used, and leakage
protector with sufficient capacity must be installed.
• Repair or replace immediately all electrical wiring that
has become frayed or otherwise damaged. Do not use
wiring that shows cracks or abrasion damage along its
length or at either end.
• When the unit is in the STOP position, there is still
voltage to the electrical controls.
• Copper wire cable in line with local standards shall be
used as the power line and connector wire.
• Both the indoor unit and outdoor unit shall be reliably
earthed.
• Wiring for the outdoor unit shall be made first and then
the indoor unit. The air conditioner can only be powered
on after wiring and pipe connection.
WARNING
RISK OF FIRE. Could cause injury or death.
• Do not store or use combustible materials, gasoline or other flammable vapors or liquids in the vicinity of this or any
other appliance.
ATTENTION
• Please do not use extension cords in this system.
• Aluminum building wiring may have special problems, please consult a licensed electrician.
• If the unit has the leak detection system installed, the unit must be powered except for service.
For any service which requires entry into the refrigerant
sealed system, Federal regulations require that the
work is performed by a technician having a Class II or
Universal certification.
Bekijk gratis de handleiding van Haier Caliber US12CB2BEA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | Caliber US12CB2BEA |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 18062 MB |
