Handleiding
Je bekijkt pagina 17 van 70
31-5001078 Rev. 0 17
ENGLISH
INSTALLATION INSTRUCTIONS
Step 3 - Installation of the Outdoor Unit
C. Electrical Connections for the Outdoor
Unit
WARNING
RISK OF ELECTRIC SHOCK.
Could cause injury or death.
Make sure power is off before touching wires.
NOTE: Be certain all wiring complies with local building
codes and NEC and that the supply voltage for this
system is correct.
• Connect the wiring for both the power source and the
indoor wiring using a conduit cable bracket on the side
of the outdoor unit.
• Using a wire stripper, remove the insulation and
separate the wires.
• Verify that the wiring connections match the indoor
connections wire for wire.
• Spade terminals are recommended. If spade terminals
are not used then the wires should not be twisted prior
to connecting to the screw terminals.
• Ensure each wire is under the screw terminal plate and
the plate is tightened with no fraying.
• Ensure the 14/4 control cable and the 16/2 high speed
communication cable are both secured under the
strain relief bracket.
• Verify that all connections are secured.
NOTE: Models 1QFF24* and 1Q3036* must connect
ground to the provided screw on the chassis, not the
ground screw of the terminal block.
NOTE: Failure to follow the wiring guidelines can result
in control board damage and communication issues
(E7 error code). This includes improper wire size, use
of solid core wire, midline splicing and poor terminal
connections.
Outdoor Unit
Centralized controller
Power wiring
Control wiring
Note:
1Q3036FF2*** models can operate at either 36K or 30K
capacity, to match the capacity of the connected indoor
unit. The default setting from the factory is 36K.
To change capacity from 36k BTUs to 30k BTUs,
change the SW2–4 dip switch by following the below
instructions:
Step 1: Remove the top cover.
Step 2: Remove the right cover.
Step 3: The SW2-4 must be adjusted to OFF
SW2-1: ON
SW2-2: OFF
SW2-3: OFF
SW2-4: OFF
DIP Switch is here:
Bekijk gratis de handleiding van Haier 1Q12TE1BEA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | 1Q12TE1BEA |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 9469 MB |
