Hager VR10129005 handleiding
Handleiding
Je bekijkt pagina 47 van 64
Standardisation and testing
Standardisation
11 Standardisation and testing
Standardisation
The EN 50085 series of standards specifies the general requirements for electrical installation duct
systems. In particular, Part 2-2 describes the requirements for floor installation systems and took ef-
fect in July 2009.
The standard is divided up into two sections:
– Erector specifications
The electrical installation engineer is usually responsible for compliance with the requirements de-
scribed in the erector specifications.
– Device testing specifications
The device test specifications specify the testing criteria of the products/devices. The manufacturer
of the products/device is responsible for compliance with it.
Device testing specifications
- Define the function of the product/device
- Define the load capacity of the product/device
- Define the area of use of the product/device
- Are primarily responsible for the safety of the product/device (e.g. protection against electric
shocks)
Classification of floor installation systems
EN 50085-1, as a general section for electrical installation trunking systems, and EN 50085-2-2, as a system-specific sec-
tion for floor installation systems, prescribe a classification of the products.
This standardises product properties across Europe. For the first time, a standard for installation systems has also been giv-
en an optional load test for vertical loads that impact over a large area (heavy duty).
Classification according to EN 50085-1
6.1 Based on material
6.2 Based on impact resistance
6.3 Based on temperature
6.4 Based on resistance to flame propagation
6.5 Based on electrical conductivity
6.6 Based on electrical insulating properties
6.7 Based on degrees of protection afforded by housing/casing in accordance with EN 0529:1991
6.8 Based on protection against corrosive or contaminated substances
6.9 Based on fastening type for system duct cover
06:10 h Based on electrical protection separation
Classification according to EN 50085-2-2
6.101 Based on type of floor care
6.102
Based on resistance to vertical loads applied to a small area (Ø +/-13 mm)
6.103
Based on resistance to vertical loads applied to a large area (Ø +/-130 mm)
Table 13: Classification according to EN 50085
Testing
Load testing of electrical installation duct systems
Electrical installation duct systems for electrical installations must conform with the standard (DIN) EN
50085-2-2.
47
Bekijk gratis de handleiding van Hager VR10129005, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hager |
| Model | VR10129005 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13434 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Certificering | EN50085-2-2 |
| Duurzaamheidscertificaten | RoHS |
| Aantal | 1 |
