GW Instek GPE-1323 handleiding
Handleiding
Je bekijkt pagina 7 van 51
SAFETY INSTRUCTIONS
7
Cleaning the
device
• Disconnect the power cord before cleaning.
• Use a soft cloth dampened in a solution of mild
detergent and water. Do not spray any liquid.
• Do not use chemicals or cleaners containing
harsh products such as benzene, toluene, xylene,
and acetone.
Operation
Environment
• Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (note below)
• Relative Humidity: < 80 %
• Altitude: < 2000 m
• Temperature: 0 °C to 40 °C
(Pollution Degree) EN 61010-1:2010 specifies the
pollution degrees and their requirements as
follows. The GPE series falls under degree 2.
Pollution refers to “addition of foreign matter,
solid, liquid, or gaseous (ionized gases), that
may produce a reduction of dielectric strength
or surface resistivity”.
• Pollution degree 1: No pollution or only dry, non-conductive
pollution occurs. The pollution has no influence.
• Pollution degree 2: Normally only non-conductive pollution
occurs. Occasionally, however, a temporary conductivity caused
by condensation must be expected.
• Pollution degree 3: Conductive pollution occurs, or dry, non-
conductive pollution occurs which becomes conductive due to
condensation which is expected. In such conditions, equipment
is normally protected against exposure to direct sunlight,
precipitation, and full wind pressure, but neither temperature
nor humidity is controlled.
Storage
environment
• Location: Indoor
• Relative Humidity: < 70 %
• Temperature: −10 °C to 70 °C
Bekijk gratis de handleiding van GW Instek GPE-1323, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GW Instek |
| Model | GPE-1323 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4219 MB |
