Growatt MAX 100-125K TL3-X BT handleiding

Niet gecategoriseerd

Growatt

37 pagina's

PDF beschikbaar

Handleiding

7.1.2 Set inverter time and date

Method 1:

Please refer to section 8.2.1 and login ShinePhone APP.Click "system time(45-50)"to set

inverter time and date on the parameter setting page.

7.2 Operation Mode

2827

Fig 7.2

7.3 LED Display

7.2.1 Waiting mode

7.2.2 Working mode

7.2.3 Fault mode

7.2.4 Off mode

When the DC voltage is more than 180Vdc, inverter will be powered on and enters the

"waiting" state.

At this mode, inverter will check the system parameter. If the system is normal and PV

voltage is more than 195Vdc, inverter will try to connect to the grid.

At this mode, inverter work normally,and the Power or fault code indicator light shows

the power delivered by the inverter to the grid.

When the DC voltage is more than 180Vdc,inverter converts the DC power generated by

the PV modules into AC power and supplies them to the grid.

When the DC voltage is lower than 180Vdc, inverter will enter into “waiting” state and

try to connect to the grid, at this status, inverter consume very small power to check the

internal system status.

Note: only when the PV modules supply enough power(voltage＞195Vdc) then the

inverter will start automatically.

Inverter intelligent control system will continuously monitor and adjust system

status.When there is a fault detected, LED will show the fault message.

Note: Please refer to section 8.2 to check the fault message and take corrective

measures.

When the sunlight is weak or no light, inverter will stop working automatically. When it is

off, inverter will not consume gird power or PV module. At the same time, the LED of

inverter will be turned off.

Note: When PV string DC voltage is too low(≤150Vdc), inverter will be off.

Inverter current operation status can be visually checked from LED display directly.

Fig 7.4

Fig 7.3

Description of LED status

Position

of LED

Type of LED

Inverter status

LED status

PV voltage

indicator light

PV voltage reaches grid

voltage

Green light is on

PV voltage does not reach

the grid voltage

Light is not on

AC voltage

indicator light

Inverter is in the grid state

Green light is on

No AC voltage

Light is not on

With AC voltage, inverter is

in the grid countdown state

The green light flashes slowly,

and the alarm or fault

indicator light is not on

Bekijk gratis de handleiding van Growatt MAX 100-125K TL3-X BT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.