Growatt MAX 100-125K TL3-X BT handleiding

Niet gecategoriseerd

Growatt

37 pagina's

PDF beschikbaar

Handleiding

6.3.2 USB port

In MAX-X series inverters, RS485 interface is standard. The connection steps of RS485

communication line are as follows:

1) Unscrew the waterproof cover of the COM interface and remove it.

2) Connect the RS485 communication line to the port of 485-1.

3) The inverter is connected hand in hand through the RS485 communication line, and

the end of the communication line 485_A/B is connected to the monitoring equipment to

realize multi-machine remote monitoring.

Note: When locking the RS485 cable screw, the torque is 0.4-0.6N·m (4-6kgf·cm).

Fig 6.7

The MAX-X series inverters are equipped with a USB interface as standard, which can be

connected to a USB to WIFI module, Shine GPRS-X2, Shine WIFI-X, Shine 4G-X, Shine

Link-X and other optional monitoring modules to realize remote Monitoring function. In

addition, you can also quickly upgrade the inverter software through the U disk.

Steps to install the monitoring module:

1> Loosen the waterproof cover of the USB interface and remove it.

2> As shown in Figure 6.8A, insert the Shine GPRS-X2 module into the USB interface,

and the LED of the Shine GPRS-X2 module will be on.

3> As shown in Figure 6.8B, make sure that the △is facing upwards, insert the

monitoring module into the USB interface, and tighten the lock.

Note: If you use a USB to WIFI module, when the operator leaves, please take the module

and the data cable away, and tighten the waterproof cover to prevent water from

entering the interface.

Fig 6.8A

Fig 6.8B

The Inverter Side

Installation

Remove

Bekijk gratis de handleiding van Growatt MAX 100-125K TL3-X BT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.