Greentec CAS 600 handleiding
Handleiding
Je bekijkt pagina 30 van 32
Maintenance and disposal
13
Manual CAS 600
EN
Maintenance
Replacing the pre-filter
Every 2 years, it is recommended to replace the pre-filter.
1. Switch off and unplug the device from the socket.
Do not touch the plug or the device with damp or wet hands. Otherwise, there is a threat of electric
shock.
Wear gloves and a mask! Otherwise, there is a risk of exposure to contamination, viruses,
bacteria and similar potential hazards.
2. Open the back plate as described in the chapter Installation.
3. Now carefully extract the pre-filter as described in the chapter Installation.
4. Put the replacement filter into the device in the same position as the old filter.
5. Again, complete the respective steps described in the chapter Installation in order to close the back plate
properly.
6. Dispose of the used filter in your domestic waste.
Replacing the main filter
Every 1500 hours of operation, the ‘RESET’ icon will light up and remain lightened, which means that the main filter
(HEPA-13 & activated carbon compound filter) needs to be replaced. The filter may need to be replaced in
shorter intervals when there is a higher level of dirt in the air as usual.
Dirty filters inhibit the performance of the device. Errors that arise when filters needs to be replaced are
described in chapter Troubleshooting.
1. Switch off and unplug the device from the socket.
Do not touch the plug or the device with damp or wet hands. Otherwise, there is a threat of electric
shock.
Wear gloves and a mask! Otherwise, there is a risk of exposure to contamination, viruses,
bacteria and similar potential hazards.
2. Open the back plate as described in the chapter Installation.
3. Now carefully extract the filter.
4. Put the replacement filter into the device. Please ensure that the tab side (side with strip) is facing you.
5. Again, complete the respective steps described in the chapter Installation in order to close the back plate
properly.
6. Put the used filter into the remaining bag of the new filter, seal the bag and immediately dispose of it in
your domestic waste. If you notice that any of the parts on or in the device not listed here are missing or
damaged, please contact your local retailer or manufacturer.
7. Then connect the device to power supply, switch it on and press the ‘RESET’ button on the control panel
for 5 seconds in order to confirm replacement of the filters and to reset the counter.
Storage
The following storage conditions must be ensured when the device is not in use:
- Take the battery out of the remote control and store the batteries separately from the remote control.
- Unplug the device before storing it.
pre-filter
HEPA-13 & activated carbon compound filter
Bekijk gratis de handleiding van Greentec CAS 600, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Greentec |
| Model | CAS 600 |
| Categorie | Luchtreiniger |
| Taal | Nederlands |
| Grootte | 7284 MB |
