Handleiding
Je bekijkt pagina 16 van 33
Child lock function
Replacement of batteries in
remote controller
Press "▲" and "▼" simultaneously to turn on or
turn off child lock function. When child lock func-
tion is on, " " icon is displayed on remote control-
ler. If you operate the remote controller, the " "
icon will blink three times without sending signal to
the unit.
signal sender battery
reinstall
remove
Cover of battery box
Temperature display switchover function
Under OFF status, press "▼" and "MODE" buttons
simultaneously to switch temperature display
between
℃ and ℉.
1.
Press the back side of remote controller
marked with " ", as shown in the fig, and then
push out the cover of battery box along the
arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" po
lar
are correct.
Reinstall the cover of battery box.
2.
3.
During operation, point the remote control signal
sender at the receiving window on indoor unit.
The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
Signal may be interfered easily in the room where
there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
Replace new batteries of the same model when
replacement is required.
When you don
't use remote controller for a long time,
please take out the batteries.
If the display on remote controller is fuzzy or there
's
no display, please replace batteries.
●
●
●
●
●
The auto clean function can only work under normal
ambient temperature. If the room is dusty, clean it
once a month; if not, clean it once every three
months. After the auto clean function is turned on,
you can leave the room. When auto clean is finished,
the air conditioner will enter standby status.
This function is only available for some models.
●
11
NOTICE
●
Auto clean function
NOTE
●
Under unit off status, hold "MODE" and "FAN"
buttons simultaneously for 5s to turn on or turn off
the auto clean function. When the auto clean func-
tion is turned on, indoor unit displays "CL" . During
the auto clean process of
evaporator, the unit will
perform fast cooling or fast heating. There may be
some noise, which is the sound of flowing liquid or
thermal expansion or cold shrinkage. The air con-
ditioner may blow cool or warm air, which is a
normal phenomenon. During cleaning process,
please make sure the room is well ventilated to
avoid affecting the comfort.
●
●
button
Having set X-FAN function on: After turning off the
unit by pressing
" " button indoor fan will continue
running for a while at low speed. In this period,
press X-FAN button to stop indoor fan directly.
Having set X-FAN function off: After turning off the
unit by pressing
" " button, the complete unit will
be off directly.
Pressing this button in COOL or DRY mode, the icon
" " is displayed and the indoor fan will continue
operation for a while in order to dry the indoor unit
even though you have turned off the unit. After ener-
gization, X-FAN OFF is defaulted.
X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator
of indoor unit will be blowed after the unit is stopped
to avoid mould.
NOTE
Bekijk gratis de handleiding van Gree GSC24UZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gree |
| Model | GSC24UZ |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 5018 MB |
