Graphite Energy+ 58G012 handleiding

79 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 9 van 79
9
When the battery is not in use, keep it away from metal objects
such as paper clips, coins, keys nails, screws, or other small
metal items that can short-circuit the battery terminals. Short-
circuiting the battery terminals can cause burns or fire.
In the event of damage and/or misuse of the battery, gases may
be released. Ventilate the room, consult a doctor in case of
discomfort. The gases may damage the respiratory tract.
Fluid leakage from the battery can occur in extreme conditions.
Liquid leaking from the battery can cause irritation or burns. If
a leak is detected, proceed as follows:
- Carefully wipe off the liquid with a piece of cloth. Avoid contact of the
liquid with the skin or eyes.
- if the liquid comes into contact with the skin, the relevant area on the
body should be washed immediately with copious amounts of clean
water, or neutralise the liquid with a mild acid such as lemon juice or
vinegar.
- if the liquid gets into the eyes, rinse them immediately with plenty of
clean water for at least 10 minutes and seek medical advice.
Do not use a battery that is damaged or modified. Damaged or
modified batteries can act unpredictably, leading to fire, explosion or
danger of injury.
The battery must not be exposed to moisture or water.
Always keep the battery away from a heat source. Do not leave it in
a high temperature environment for long periods of time (in direct
sunlight, near radiators or anywhere where the temperature exceeds
50°C).
Do not expose the battery to fire or excessive temperatures.
Exposure to fire or temperatures above 130°C may cause an
explosion.
NOTE: A temperature of 130°C can be specified as 265°F.
All charging instructions must be followed, and the battery
must not be charged at a temperature outside the range
specified in the rating data table in the operating instructions.
Charging incorrectly or at temperatures outside the specified range
can damage the battery and increase the risk of fire.
BATTERY REPAIR:
Damaged batteries must not be repaired. Repairs to the battery
are only permitted by the manufacturer or an authorised service
centre.
The used battery should be taken to a disposal centre for this
type of hazardous waste.
SAFETY INSTRUCTIONS FOR THE CHARGER
The charger must not be exposed to moisture or water. The
ingress of water into the charger increases the risk of shock. The
charger may only be used indoors in dry rooms.
Unplug the charger from the mains before carrying out any
maintenance or cleaning.
Do not use the charger placed on a flammable surface (e.g.
paper, textiles) or in the vicinity of flammable substances. Due
to the charger's temperature increase during the charging process,
there is a danger of fire.
Check the condition of the charger, cable and plug each time
before use. If damage is found - do not use the charger. Do not
attempt to disassemble the charger. Refer all repairs to an
authorised service workshop. Improper installation of the charger
may result in a risk of electric shock or fire.
Children and physically, emotionally or mentally challenged persons,
as well as other persons whose experience or knowledge is
insufficient to operate the charger with all safety precautions, should
not operate the charger without the supervision of a responsible
person. Otherwise there is a danger that the device will be
mishandled resulting in injury.
When the charger is not in use, it should be disconnected from
the mains.
All charging instructions must be followed, and the battery must
not be charged at a temperature outside the range specified in
the rating data table in the operating instructions. Charging
incorrectly or at temperatures outside the specified range can
damage the battery and increase the risk of fire.
CHARGER REPAIR
A defective charger must not be repaired. Repairs to the charger
are only permitted by the manufacturer or an authorised service
centre.
The used charger should be taken to a
disposal centre for this type of waste.
ATTENTION: The device is designed for indoor operation.
Despite a design that is safe by design, the use of safety
measures and additional protective measures, there is always a
risk of residual injury during operation. Li-Ion batteries can leak,
catch fire or explode if they are heated to high temperatures or
short-circuited. Do not store them in the car during hot and sunny
days. Do not open the battery pack. Li-Ion batteries contain
electronic safety devices which, if damaged, can cause the
battery to catch fire or explode.
Explanation of the used pictograms
1.Read the operating instructions, observe the warnings and safety
conditions contained therein.
2.Wear safety goggles and ear protection.
3.Keep children away from the appliance.
4.Protect from rain.
5.Use indoors, protected from water and moisture.
6.Recycling.
7.Second class of protection.
8.Selective collection.
9.Do not throw the cells into the fire.
10.Hazardous to the aquatic environment.
11.Do not allow heat to exceed 50°C.
CONSTRUCTION AND PURPOSE
The impact screwdriver is a battery-powered power tool. It is
driven by a DC commutator motor with permanent magnets. The
impact driver is designed for screwdriving and unscrewing screws
and bolts in wood, metal, plastics. The device is commonly used
for the installation of self-drilling screws due to the high speed
offered and longer wood screws due to the high torque. The
device can be successfully used at heights and in hard-to-reach
spaces. The mechanism responsible for the high torque
generates it in the form of a momentary peripheral impact, and
the impact on the operator's hands during screwdriving is low.
Do not misuse the power tool.
DESCRIPTION OF THE GRAPHIC PAGES

Bekijk gratis de handleiding van Graphite Energy+ 58G012, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkGraphite
ModelEnergy+ 58G012
CategorieNiet gecategoriseerd
TaalNederlands
Grootte17448 MB