Gorenje IMDW1500B handleiding
Handleiding
Je bekijkt pagina 20 van 64
20
To restart the appliance, remove the ice basket and
add water up to the MAX sign and press POWER.
Depending on the temperature of the
environment and water, the first ice cubes may
be smaller.
Due to rapid freezing of the water, the cubes
may appear cloudy, or opaque. This is a result
of the air trapped inside the ice and it does not
affect the quality of the ice.
After the appliance has been switched to
standby mode, wait for at least 3 minutes
before starting its operation. Failure to do so
may result in compressor failure.
Replace the water in the water tank at least every
24 hours.
To prevent the development of mould and bacteria,
we recommend leaving the cover open after use
(7).
Cleaning
Before cleaning the appliance, stop its operation
and disconnect it from the power mains.
Do not clean the appliance with scouring pads,
caustic or corrosive cleaners or aggressive liquids
like alcohol, gasoline, or acetone.
Clean the appliance with a soft damp cloth. Do not
submerge the unit in water and do not clean it under
running water or in a dishwasher.
Ice basket: Clean the basket with lukewarm water
and some liquid detergent; then rinse and dry
thoroughly.
Water tank: Use the drain (11) to empty the water
tank.
Appliance interior and exterior (housing): Clean the
appliance interior and exterior with a soft damp
cloth. A diluted mixture of water and vinegar may
be used.
Trouble shooting
Trouble
Possible
reason
Solution
The indicator
above the
POWER
button will not
light up.
There is no
voltage in
the power
mains.
The
appliance is
not
connected to
the power
mains.
1. Check if there is
voltage in the power
mains.
2. Connect the appliance
to the power mains.
3. Internal appliance
components have
failed. Call Gorenje's
customer service.
Indicator
above the ICE
FULL sign is
on.
Ice basket is
full.
1. Remove the ice from
the basket.
2. Internal appliance
components have
failed. Call Gorenje's
customer service.
Indicator
above the
ADD WATER
sign is on.
There is not
enough
water in the
water tank.
1. Add water up to the
MAX sign and press
the POWER button.
2. Internal appliance
components have
failed. Call Gorenje's
customer service.
All indicators
are flashing.
Ice is
preventing
the water
tank from
moving.
1. Switch the appliance
to standby mode and
remove the ice cubes
blocking the water
tank.
2. Internal appliance
components have
failed. Call Gorenje's
customer service.
Although the
ice basket is
full, the ICE
FULL indicator
will not light up
and the
appliance will
not switch off.
The sensors
only start to
operate after
three
finished
cycles.
There is no
signal for the
sensor.
1. Disconnect the
appliance from the
power mains. Empty
the ice basket and
reconnect the
appliance after 3
minutes.
2. Powerful light is
disturbing the signal
reception Move the
appliance away from
the source of light.
3. Internal appliance
components have
failed. Call Gorenje's
customer service.
Environment
After the expiry of its useful life, do not discard the
appliance with common household waste. Take is to an
authorized recycling centre. This will help preserve the
environment.
Warranty and repair:
For more information or in case of problems, please visit
Gorenje website at www.gorenje.com or contact Gorenje
customer service in your country (phone numbers are
listed in the International Warranty Sheet). If there is no
such centre in your country, please contact the local
Gorenje dealer or Gorenje's small domestic appliance and
personal care appliance department.
For personal use only!
GORENJE
WISHES YOU A LOT OF PLEASURE IN
USING YOUR APPLIANCE.
We reserve the right to modifications.
Bekijk gratis de handleiding van Gorenje IMDW1500B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gorenje |
| Model | IMDW1500B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9538 MB |
