Handleiding
Je bekijkt pagina 9 van 12
TIMER
• The appliance will always be on when the slide switch is in the 'I' position.
• The appliance will always be off when the slide switch is in the 'O' position.
• To set the Timer; set the MODE switch to the Timer position.
(This function can only be used once a heat level has been selected ; see thermostat
section).
• You must set the time prior to programming the Timer. To do this; turn the outer
dial of the timer in a clockwise direction until the time of the day (24-hour clock)
corresponds with the triangular marking. Example if it is 2pm (1400 hours) then
set the triangular mark in line with 14. One complete turn of the dial corresponds
to 24 hours.
• There are 96 'riders', positioned around the dial, each rider represents 15 minutes.
• Where all the 'riders' are pushed to the outside of the timer the appliance will be
ON continuously.
To set a specific time for example:
• If you want the appliance to be on from 6pm to 10pm, then set all the riders from
18 to 22 (1800 hours to 2200 hours) to the outside of the rim and all other riders
to the inside of the timer. The unit will then turn on automatically at 6pm and off
again at 10pm.
Operating Your Heater
Bekijk gratis de handleiding van GoldAir GCV290B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GoldAir |
| Model | GCV290B |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 1516 MB |
