GLP MAD MAXX handleiding
Handleiding
Je bekijkt pagina 10 van 32
www.glp.de GLP Mad Maxx
10 MAD MAXX Quick Start and Safety Manual
● Installation must be performed by qualified personnel only and carried out in
accordance with applicable regulations such as DIN VDE 0711-217.
● Ensure that any surface or structure that the fixture is placed on or suspended
from, and all installation hardware used, can hold at least ten times the weight of
the load that they support. All rigging hardware must be approved for the weight
that it will support. Ensure that the supporting surface or structure is stable and
can safely handle any forces that result from pan and tilt movement of the
fixture’s head.
● Install the fixture only as directed in this manual and only with hardware that is
specifically designed, approved and rated for its purpose. Do not use a safety
chain or safety cable as the primary means of support.
● Check that installation hardware is in perfect condition. Fasteners must be steel
grade 8.8 strength or better. Nuts must be self-locking type and in good
condition. Rigging clamps must be half-coupler type that completely encircle the
rigging truss chord and approved for the weight that they will support.
● The fixture may be used standing on a secure, stable surface. The fixture may be
suspended hanging vertically downwards only from a secure rigging truss using
the two truss mount bars available from GLP suppliers as accessories for the
fixture and minimum two rigging clamps per truss bar.
● Allow a minimum center-to-center distance of 600 mm / 24 in. between fixtures
when installed.
● If the fixture is installed in a location where it may cause injury or damage if it falls,
secure it as directed in this manual against the failure of a primary attachment
using at least one safety chain and shackle supplied by GLP for the fixture (or
similar approved chain or cable and shackle with minimum 1 tonne SWL). All
safety chains, cables and shackles used must be approved by an official body such
as TÜV as a safety attachment for the weight that they secure and they must
comply with EN 60598-2-17 Section 17.6.6. Ensure that the chain will hold the
fixture if a primary attachment fails. Remove all slack from the safety chain to
minimize any drop by the fixture if a primary attachment fails.
● If the fixture is installed in a location where it may be exposed to forces such as
wind pressure, vibration or movement, make sure that the installation can
withstand these forces. Monitor weather forecasts constantly. Take down the
installation immediately if there is any risk of weather conditions that could
destabilize the installation.
● Check that all covers and items of rigging hardware are secure before using the
fixture. Do not operate the fixture with missing or damaged covers, shields or any
optical component.
● Restrict access below the work area and work from a stable platform whenever
installing, servicing or moving the fixture.
● If the fixture becomes damaged, stop using it immediately and disconnect it from
power. Do not attempt to use a fixture that is obviously damaged.
● Do not modify the fixture in any way not described in its user documentation.
● Install genuine GLP parts only.
Bekijk gratis de handleiding van GLP MAD MAXX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | MAD MAXX |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4369 MB |
