GLP JDC1 handleiding
Handleiding
Je bekijkt pagina 18 van 76
www.glp.de
18 JDC1 User Manual Rev. 20240830-01
In Percentage flash control mode, you set the duration of Beam and Plate flashes on
their respective duration channels as a percentage of the flash on/off cycle. Once
you have set this percentage, flash duration is automatically adjusted to match flash
rate. If you increase the flash rate, the duration of flashes will be reduced. Percentage
flash control mode makes it easy to control flashes using the rate channel only.
In Aggressive flash control mode, flash rate and duration are controlled as in Normal
flash mode, but if intensity on the Plates is below 100%, the extra available power is
pushed to the Beam LEDs. This gives an even more powerful Beam flash than in the
other flash modes.
If Plate LEDs are at zero intensity, enabling Aggressive flash mode will give maximum
Beam flash intensity. If you increase Plate intensity, Beam and Plate output will be
balanced to give the best performance. If you set Plate intensity to maximum, Beam
intensity will be the same as in Normal flash mode.
Flash Modes can be changed very quickly (hold for 0.5 seconds) by programming the
setting in the cue directly. This means that it is possible to swap between flash modes in
the middle of a show.
Dimmer flash control mode
Producing single flashes is quick and easy if you activate Dimmer Flash mode in the
Settings control menu. Activating this mode affects both the Beam and the Plates.
With Dimmer flash mode enabled, if the Shutter channel (6 for the Beam and 10 for the
Plates) is set to zero, any new DMX value that you input on the Intensity channel (3 for
the Beam and 8 for the Plates) will produce a single flash on the Beam or Plates. In
effect, all you need to do is 'nudge the dimmer fader' to produce a flash.
FX
DMX Modes 2 and 3 include pre-programmed FX on channels 15-19. The FX are
dynamic patterns that are superimposed onto the Beam and/or the Plate LEDs.
Normally, all the Beam or all the Plate pixels flash at the same time. But when you
select an FX, only the pattern pixels flash.
The following control options are available via DMX when using FX:
• Select FX pattern and speed for the Beam
• Select FX pattern and speed for the Plates
• Adjust crossfade time (fade time between FX pattern and background).
For tables showing all the patterns available on the Beam and the Plates, see pages 64
and 69.
Bekijk gratis de handleiding van GLP JDC1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | JDC1 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 9927 MB |
