GLP impression X5 handleiding
Handleiding
Je bekijkt pagina 23 van 84
German Light Products®
Rev. 20240207-01 23
You can take the fixture out of hibernation mode with a power off/on cycle, via RDM
or using the Special / Control DMX channel. If you do this, the fixture will perform a
fixture reset before returning to normal operation.
Load User Settings
Lets you load different custom fixture configurations or return the fixture to the default
fixture settings.
To save a custom setting preset from 1 to 3, see Service
→
Advanced
→
Save_Settings.
● Load User Settings 1 to 3 loads one of three specific custom fixture settings. You
must confirm the function for 3 seconds before the new settings are loaded (see
Fixture Settings
→
Load User Settings).
● Save User Settings 1 to 3 saves the current fixture settings as a set of user settings.
You must confirm the function for 2 seconds in order to save the settings as one of
the three custom settings presets (see Service
→
Advanced
→
Save User Settings).
Note: The Load User Setting Presets and Load User Setting Defaults commands will only
affect settings in the Fixture Settings group and will not affect DMX Address, Control
Mode, Protocol Type, IP Settings, etc. This helps avoid loss of communication with the
controller.
Information
The Information submenu provides readouts of all relevant information such as the error
list if any errors have been detected, the fixture’s serial number, firmware version,
device info, device hours counter, power cycles counter, DMX input monitor, signal
quality etc.
Manual Control
This submenu gives different options for resetting the fixture manually. It can be helpful
for service or stand-alone issues.
● Reset All: Performs a full fixture reset to initialize all features and effects.
● Reset P/T: Resets pan and tilt only to initialize pan and tilt positions.
● Reset Head: Resets all the features in the head.
Manual DMX
Gives individual control of the fixture using the fixture user interface. The menu timeout
function is disabled as long this menu is open.
● Manual Control: Manually sets a DMX value for each function.
● Reset Manual values: Resets all manual control values to default.
External DMX values will always have higher priority than manual control commands.
Disconnect the fixture from the data source when using manual control.
Note: When entering manual control, be prepared for the fixture to start moving.
Bekijk gratis de handleiding van GLP impression X5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression X5 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 13957 MB |
