GLP impression X5 handleiding
Handleiding
Je bekijkt pagina 21 van 84
German Light Products®
Rev. 20240207-01 21
Pixel rotation
Lets you rotate the fixture’s pixel layout by: 0° – 60° – 120° – 180° – 240° – 300°.
No signal
The No signal settings let you manage how the fixture behaves if no DMX signal is
present (if the fixture is being controlled by DMX but the DMX signal stops, or if you
apply power to the fixture when no DMX signal is present):
● Blackout sets the fixture to black out whenever it is not receiving a DMX signal. This is
the default setting.
● Hold sets the fixture to continue using the last DMX values it received.
● Scene (Stand-alone) sets the fixture to play its stored stand-alone scene (see
Capture DMX Values below) when the fixture is not receiving a DMX signal. If no
stand-alone scene is stored in memory, the fixture will black out.
If the fixture is set to Scene (Stand-alone) and if a stand-alone scene has been
stored in its memory using the Capture DMX Values command, it will display its
stand-alone scene at all times when it is powered on but not receiving a DMX
signal. You can therefore use this setting if you want fixtures to automatically start
stand-alone operation when you apply power to them.
● Capture DMX Values takes a snapshot of the DMX values that are currently being
received and stores them in the fixture’s memory as its captured scene. The fixture
will display this scene if it is set to Scene (Stand-alone) (see above) and is not
receiving a DMX signal.
Pan invert
With the fixture standing on the ground, increasing the pan DMX value normally moves
the yoke clockwise from its home position.
Changing the Pan invert setting to ON inverts the pan direction so that increasing the
pan value turns the yoke counterclockwise.
Tilt invert
With the fixture standing on the ground, increasing the tilt DMX value moves the head
towards the front from its home position.
Changing the Tilt invert setting to ON inverts the tilt direction so that increasing the tilt
value turns the head towards the back (towards the gray safety eyelet).
Position feedback
Pan and tilt auto-correction (position feedback) is normally enabled (On). Changing
this setting to OFF will disable the position feedback and auto-correction. If you need
to return pan and tilt to their correct positions, you must perform a reset.
Pan/Tilt disable
Changing the Pan/Tilt disable setting to "Current disable" de-activates pan and tilt by
disabling the pan and tilt motor current.
Bekijk gratis de handleiding van GLP impression X5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression X5 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 13957 MB |
