GLP impression X5 IP Bar 1000 Handleiding (84 Pagina's)

Handleiding

German Light Products® X5 IP Bar 1000

Rev. 20240207-01 31

6. Setting up the control protocol

The impression X5 IP Bar 1000 can be controlled via:

● USITT512 DMX over a standard DMX cable link using the fixture’s 5-pin XLR

connectors,

● GLP’s wireless iQ.Mesh technology.

● LumenRadio CRMX (supplied). The integrated GLP FPO (Flexible Protocol Option)

port allows the installation of an optional control protocol module. The impression

X5 IP Bar 1000 is supplied with a LumenRadio CRMX module installed as standard.

Your GLP supplier can give you details of other control protocol modules that may

be available.

This section explains how to configure the fixture to use one of these control data

protocols.

Note: The control protocol settings are not affected if you apply a Fixture Settings

→

Load User Settings

→

Setting Defaults command in the fixture’s control panel, but they

are returned to factory defaults if you apply a Load Factory Defaults command in the

main menu.

DMX

The fixture is set up for control via a standard DMX cable link by default.

If the control data protocol has been changed and you want to return to DMX control

over a standard DMX cable link, open the menus in the fixture’s control panel and

make the following adjustments:

In the main menu in the fixture’s control panel, open DMX Address and give the

fixture a suitable DMX address.

In the Protocol Setup → Data In menu, set the control protocol to DMX.

iQ.Mesh

If you want to control the fixture via GLP iQ.Mesh:

Open the menus in the fixture’s control panel.

In the Protocol Setup → Data In menu, set the control protocol to iQ.Mesh.

LumenRadio CRMX

A LumenRadio CRMX module is installed as standard at the impression X5 IP Bar 1000’s

FPO port when the fixture is supplied.

If you want to control the fixture via LumenRadio CRMX, open the menus in the fixture’s

control panel and make the following adjustments:

Open the menus in the fixture’s control panel.

In the Protocol Setup → Data In menu, set the control protocol to CRMX.

Bekijk gratis de handleiding van GLP impression X5 IP Bar 1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.