GLP Impression X5 Compact handleiding
Handleiding
Je bekijkt pagina 23 van 83
German Light Products® X5 Compact
impression X5 Compact User Manual 23
Note: When changing back to OFF, you must carry out a reset before you can operate
pan and tilt normally.
Pan Range
For normal use and to make swapping fixtures easier, pan is normally limited to a
standard 540° maximum pan angle (NORMAL). However, if you wish to use the full pan
range between mechanical end positions, it is possible to extend the standard range
to the mechanical maximum (EXTENDED).
For details of pan angles, see the technical specifications in the impression X5 Quick
Start and Safety Manual supplied with the fixture and available for download from
www.glp.de.
Accessories and tilt range
If an external accessory is installed on the head, it may be necessary to limit the
fixture’s tilt angle. The following settings are available:
● None (default): The tilt angle is not limited: Maximum tilt angle is possible.
● Egg Crate: Maximum tilt angle is limited to allow the installation of an optical
accessory such as the GLP Egg Crate Extension.
Display Mode
Gives different display behavior options. This can be helpful in case of errors or service
situations.
● Auto (default): the display automatically switches off after a few seconds if the
fixture is receiving a valid control signal and has not detected an error. If the fixture
is not receiving a valid control signal, the display will flash. If the fixture has
detected an error, the display remains constantly on and shows an error message.
● On: The display stays on constantly. This setting can be useful if you are configuring
or servicing the fixture.
● Off: The display will automatically switch off after a few seconds even if the fixture is
not receiving a valid control signal or if it has detected an error. Pressing any button
turns on the display again.
Display Orientation
Lets you select Normal, Upside-down or Auto display orientation.
If Display Orientation is set to Auto, changing the display orientation by pressing UP and
DOWN at the same time will only change the display orientation until the next power
cycle.
Hibernation
Lets you put the fixture into energy-saving mode and disables all electronic
components apart from the DMX receiving module.
Bekijk gratis de handleiding van GLP Impression X5 Compact, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | Impression X5 Compact |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 13142 MB |
