GLP impression S500 Profile handleiding
Handleiding
Je bekijkt pagina 9 van 22
German Light Products®
Rev. 20250116-02 9
The PWM frequency of the LED dimming can be adjusted if you have problems with
camera flicker using the Fixture Settings → PWM Frequency option. The PWM
Frequency is shown on the top line of the screen. Higher PWM frequencies will reduce
the dimming performance / resolution.
Shutter
The fixture’s shutter channel offers continuous blackout, continuous open and a range
of intensity effects.
The following shutter effects are available:
● Pulse dims up and down smoothly with the same fade-in and fade-out times. Speed
can be adjusted from slow to fast.
● Pulse open fades in and then snaps to blackout. Speed can be adjusted from slow to
fast.
● Pulse close fades out and then snaps to full. Speed can be adjusted from slow to
fast.
● Strobe random strobes the fixture at random intervals, allowing a random strobe
between multiple fixtures. Speed can be adjusted from slow to fast.
● Strobe strobes the fixture at a regular speed and also perfectly synchronizes the
strobe in multiple fixtures so that all the fixtures flash at exactly the same time.
Speed can be adjusted from slow to fast.
Control / Special channel
The Special/Control DMX channel lets you change fixture settings and perform a fixture
reset from the control desk (which can be very useful during a show). To apply a
command on the Special/Control channel, you must hold the command for the time
indicated in the DMX channel index (usually 3 seconds).
To trigger a reset using the Special/Control channel, you must send the DMX value for
this function for 3 seconds. If you want to trigger an additional reset using the
Special/Control channel, you must first move away from the Reset DMX value and then
return to this value. This stops the fixture getting into an unwanted Reset loop if it is
patched wrongly.
Note: Most of the fixture settings available in the fixture’s control menus or on the
Special/Control DMX channel are also available via RDM.
Zoom
The impression S500 Profile HO/HC has motorized zoom control that lets you vary the
beam angle from wide to narrow as the DMX value increases. You can invert this using
the Fixture Settings → Zoom Invert option.
The “Performance” Setting allows you to limit the Zoom speed to control the noise
made by the zoom movement.
Bekijk gratis de handleiding van GLP impression S500 Profile, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression S500 Profile |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 2794 MB |
