GLP DoP Converter DINrail handleiding
Handleiding
Je bekijkt pagina 19 van 32
German Light Products® DoP Converter DINrail / UM
GLP DoP Converter User Manual Rev. 20220320-01 19
8. Setting up the DoP Converter
Recommended setup sequence
After physically installing the DoP Converter and making power and DMX connections,
configure the Converter as follows:
1. Select the appropriate operating mode depending on whether the Converter will
be used as a transmitter or a receiver.
2. Select the DoP channel that you want to use (see ‘Setting the DoP channel’ on
page 22).
3. Move the DMX start address if needed* (see ‘RX start address’ on page 22)
4. Lock / unlock the display or change between display modes (see ‘Locking and
unlocking the control panel’ on page 23 and ‘Display modes’ on page 23)
*Optional step
Control panel display
See illustration above. The DoP Converter’s display shows information on:
Top line:
• Currently installed device software / firmware version
• DoP Converter version (number of DMX channels available for transmission)
• Control panel locked / unlocked
• Display auto sleep setting
Second line:
• Current mode (TX or RX) followed by:
- TX mode – number of DMX channels being used for transmitting + currently
active DoP channel
V.1.2.0 512-Ch
RX-D00/001
DMX..........No Signal
DOP..........Not connected
Bekijk gratis de handleiding van GLP DoP Converter DINrail, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | DoP Converter DINrail |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3150 MB |