GLP ArenaLED1 Touring handleiding
Handleiding
Je bekijkt pagina 6 van 33
www.glp.de GLP ArenaLED1 Touring
6 GLP ArenaLED1 Touring Safety and User Manual
● If you link devices to AC mains power in a daisy chain by running power cable
from THRU/OUT connectors to IN connectors, add together the total current
draw of all the devices that you intend to connect together, including the first
device, and check the current ratings of all elements (circuits, cables and
connectors) in the chain. Do not exceed the current rating of any element in the
chain.
● You may connect a MAXIMUM of EIGHT (8) ArenaLED1 Touring fixtures to mains
power together in a daisy chain.
● To ensure IP65 protection, only use IP65-rated connectors from the same
manufacturer and of the same type as those installed on the fixture. This applies
in particular to power input and power relay cables. If a cable connector is not in
perfect condition, install a new connector on the cable following the connector
manufacturer’s instructions. Send old connectors for recycling.
● The fixture’s connectors are equipped with tethered rubber seals. Apply the
rubber seal to every connector that does not have a plug inserted in it so that
the connectors are protected from water and moisture.
● Use a power cable that is minimum 14 AWG or 1.5 mm
2
, minimum 16 A-rated and
temperature-rated to suit the application. In the USA and Canada the cables
must be UL-listed, type SJTW or equivalent. In the EU the cables must be type
H05RN-F or equivalent, or for outdoors applications cables must be type H07RN-
F or equivalent.
● Make sure that cables open into dry areas or sealed junction boxes. Moisture can
be drawn along cables by capillary action or pressure variations resulting from
thermal expansion.
● Arrange cables so that they arrive
at connectors from below. Make
sure that it is impossible for water
to flow down cables and
accumulate at connectors. If
necessary, provide extra cable
slack and create ‘drip loops’
before connectors.
● Some internal components carry a high voltage while the device is connected to
AC mains power. Some of these components can remain live for up to 30
minutes after the power supply has been disconnected.
Fire safety and protection from burns
● Do not operate the fixture if the ambient temperature exceeds 45° C (115° F).
● The hottest parts of the fixture’s surface can reach up to 100° C (212° F) during
operation. Avoid contact by persons and materials. Do not install the fixture in a
Bekijk gratis de handleiding van GLP ArenaLED1 Touring, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | ArenaLED1 Touring |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 1825 MB |
