Gladiator GAWUXXSHRH handleiding
Handleiding
Je bekijkt pagina 7 van 44
7
Install the GearWall
®
Panels
■ Snap a level chalk line at a convenient height on the wall(s).
Measure from the chalk line to the ceiling and determine the
lowest point of the ceiling along the wall.
■ Starting from the lowest point of the ceiling, measure down
to the oor. Round the measurement down to the nearest
foot and mark. Snap a level chalk line ¹⁄4” (6.3 mm) below the
mark. Repeat step for remaining walls.
NOTE: For partial wall installation, simply snap a level chalk
line at the desired height of the bottom of the wall.
1. Measure Ceiling Sag
2. Mark Bottom of Wall
Plan your Installation
■ Install the rst stud at the starting edge of the desired
coverage area to act as a guide. Drill a hole through the
stud and into the wall surface. Follow masonry screw
manufacturer’s instructions for proper installation. For best
results use a hammer drill and masonry bit.
NOTE: For extra hold, you may choose to put
construction adhesive on the stud before attaching it to
the wall.
■ Secure the stud to the wall by placing ¹⁄4” (6.3 mm) x 2³⁄4”
(6.9 cm) masonry screws every 18” (45.72 cm).
1. Mount First Stud
2. Secure First Stud
Prepare the Wall
Masonry Block / Poured Concrete Wall
■ Before you can install the panels on poured concrete or masonry block walls, you must install 2" (5.08 cm) x 4" (10.16 cm) wooden
studs to the wall with the 4" (10.16 cm) side against the wall. The wooden studs must be installed over the entire area to be covered
by the GearWall
®
panels. This provides a level surface on which to mount the panels.
B
A
A. Masonry screws
B. Wooden stud
Bekijk gratis de handleiding van Gladiator GAWUXXSHRH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gladiator |
| Model | GAWUXXSHRH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5072 MB |
