Gladiator GAWU12CCTG handleiding
Handleiding
Je bekijkt pagina 5 van 16
5
4. Repeat steps 1 through 3 to attach the lower mounting
bracket.
NOTE : Hand tighten the nuts attaching the lower bracket. In
order to mount the golf caddy on the wall, this bracket will
need to be adjusted.
5. Using Phillips-head screws (F3b) and acorn nuts (F10), attach
the golf bag divider to the 4 holes in the center of the upper
mounting bracket.
Mount the Golf Caddy to the Wall
IMPORTANT : If Gladiator
®
GearTrack
®
channels will be used to
mount the golf caddy, they must be installed 18" (46 cm) apart.
1. Determine caddy mounting location on GearWall
®
panel or
GearTrack
®
channels.
2. Engage the upper mounting bracket into the wall slots by
lifting up, pushing toward the wall and lowering the bracket
rims into the slots.
3. Inspect the golf caddy from the side to ensure the upper
mounting bracket rims are fully engaged in the slots as shown.
A
B
C
E
D
A
B
C
B
18
" (46 cm)
A
B
C
4. Grasping the bolts, lift up on the lower mounting bracket to
align the bracket rims with the slots on the GearWall
®
panel or
GearTrack
®
channel.
5. Push the golf caddy toward the wall and lower the lower
bracket rims into the slots.
NOTE: Make sure the lower mounting bracket is fully engaged
in the slots.
6. Using a 1/2" (1.27 cm) wrench, tighten the nuts on the lower
mounting bracket.
7. Inspect the golf caddy from the sides to ensure both the upper
and lower mounting brackets are fully engaged in their
respective slots as shown.
8. Attach each strap to the side panel and to the D-ring on the
golf bag divider, as shown.
CLEAN-UP CADDY
Assemble Clean-Up Caddy
1. Insert the threaded studs at the top of each side piece into the
two holes in each side of the caddy back.
NOTE : Make sure the bracket rim on the caddy back is to the
outside of the side pieces.
2. Using two acorn nuts (F10) per side, attach the sides to the
back. Completely tighten with a 3/8" (9.52 mm) nut driver.
3. Attach the caddy shelf (with the name badge facing up) by
interlocking the shelf tabs with the tabs on the back.
NOTE : Make sure the lower mounting bracket is fully
engaged in the slots.
4. Using the two Phillips-head screws (F3b) and two acorn nuts
(F10) fasten the caddy shelf to the sides.
5. Holding each screw in place with a screwdriver, completely
tighten the acorn nut with the nut driver.
F3b
F3b. Phillips-head screw (2)
F10
F10. Acorn nut (6)
A
A
A
B
A. Bracket rim C. Mounting bracket
B. Slot fully engaged
A. Acorn nuts (F10)
A. Bottom piece
A. Phillips-head screw (F3b)
B. Acorn nut (F10)
Bekijk gratis de handleiding van Gladiator GAWU12CCTG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gladiator |
| Model | GAWU12CCTG |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2627 MB |
