Gladiator GAWALP8PPH handleiding
Handleiding
Je bekijkt pagina 5 van 42
5
Install the GearTrack
®
Channels
Prepare the Wall
Masonry Block / Poured Concrete Wall
■ Before installing GearTrack
®
to masonry walls, you must waterproof the walls to avoid mildew or foundation damage. Walls that
appear dry may actually become damp when enclosed by paneling. Install the channels in accordance with all local codes and
ordinances.
Wood Studs and Drywall over Wood Studs
■ Use a stud nder to mark the edges of the studs within your
planned installation area. Be sure to also mark the locations of
electrical wiring.
IMPORTANT: Compare screw length to electrical wiring
locations. Be sure the screw will not pierce electrical wiring.
■ If necessary, cut the rst channel to this length, making sure
the cut is square.
NOTE: Channels cut to shorter than 24" (60.96 cm) long should
not be used.
■ GearTrack
®
Channels should be mounted to the wall so that
they begin and end at wooden studs. Measure from the center
of the stud at the beginning of the desired coverage area to the
center of the last wooden stud that is within 32" (81.3 cm),
42" (106.7 cm) or 48" (121.9 cm), depending on the length of
your GearTrack
®
Channel.
Stud Finder
1.
Locate Studs and Electrical
2. Measure the Channels
3. Cut to Length
Bekijk gratis de handleiding van Gladiator GAWALP8PPH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gladiator |
| Model | GAWALP8PPH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5609 MB |
