Girmi AP31 handleiding
Handleiding
Je bekijkt pagina 12 van 32
11
Do not overfill the water tank and do not to introduce into
the tank mixtures for removing stain, vinegar, descaling
agents or chemicals in general.
Do not use the device as a heating unit.
Do not expose the product to high temperatures and do
not place it near heat sources. Do not immerse in water or
other liquids; always clean it with a damp cloth.
Fill the tank when you notice a decrease in the jet of
steam. Before filling the tank, disconnect the power cord
from the electrical outlet.
When using, do not tilt over 45°. Do not direct the flow of
steam towards people, animals, electrical equipment,
CAUTION: the steam outlet nozzle becomes very hot:
be careful not to burn yourself. Do not put your face
in front of the steam coming out of the nozzle.
DESCRIPTION AP31
(1) Tank (2) Short spout (3) Safety cap (4) Steam emission button
(5) Handle (6) Power cord (7) Control light (8) Funnel
(9) Measuring cup (10) Round brush (11) 90° nozzle (12) Main spout
(13) Flexible hose (14) Brush (15) Mirror brush (16) Cloth
OPERATING
The device can be used to disinfect and sterilize surfaces, clean clothes, doors, windows, mirrors, remove the
dirt in the grooves between tiles, etc. ...
- Unscrew the cap (3) by turning it counterclockwise.
- To fill the tank, insert the funnel (8) and enter the water using the measuring cup (9, 150ml capacity)
without exceeding the maximum capacity of the tank (350ml).
- Screw the cap and connect the plug to the power outlet. The red lamp (7) will light on and the boiler starts
heating up. When the green light (7) goes on, it means that the boiler is ready to produce steam.
- On first use, or if the product did not operate for a long time, it is recommended to expel steam by using
the proper button (4) for about 2 minutes on a cloth. This will eject processing residues and limestone.
- For using the steam, press the steam emission button (4). The button has 2 safety systems:
o Automatic release: steam exits only when you press the button, if you release the emission will stop.
o Safety lock: you can block button moving the safety lock that is under of the button.
- It is recommended to drain the remaining water after each use.
When you use the unit with steam emission, wait until the complete heating of the
boiler. CAUTION: do not fill the tank completely (max 350ml) since this operation
prevent the steam formation and causes water leaks.
ACCESSORIES
Main spout (12), for a long and localized jet of steam.
Assembling: Align the "I" mark on the spout (12) with the sign "II" on housing (Figure 1)
and then turn the nozzle clockwise until it locks. To remove it, turn it counterclockwise.
Bekijk gratis de handleiding van Girmi AP31, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Girmi |
| Model | AP31 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3019 MB |
