Giles GGF-400 handleiding
Handleiding
Je bekijkt pagina 15 van 99
• The fryer must remain in an upright (vertical) position.
• Exercise care when lifting & moving the unit.
• Use due caution when removing the wooden crating & shipping materials.
• Failure to comply with CAUTION notices may result in minor to moderate injury, damage to equipment or
property & void the manufacturer’s warranty.
6
Installation
GGF Series Gas Fryer
1. The appliance is palletized on a wooden pallet, secured with hightensile plastic strapping & protected by a
wooden crate framework. The entire unit load is wrapped with machine applied stretch film.
2. Carefully cut & remove the plastic stretch film wrap.
3. Carefully remove the wooden crate framework, cut & remove plastic strapping. Secure & remove all accessory
items (basket, pot cover, brushes, tools, filter pan, etc.). Set aside in a safe place ... properly dispose of
shipping materials.
4. Carefully remove fryer from the shipping pallet. The appliance is heavy [approximately 280 lbs, 127 kg].
Extreme care should be taken when lifting & moving the unit to prevent personal injury and/or damage to the
equipment. Use sufficient manpower and/or appropriate handling equipment.
2.2. Unpacking
1. Installation location must comply with clearances to combustibles stated in Section 2.3.
2. Provide adequate space for easy access to operate & service appliance.
3. Verify that electrical power at the intended location is proper voltage & amp rating. Each appliance requires
an isolated, properly grounded, 120V, 15A (min), nonGFCI circuit.
4. The proper type, stable fuel gas supply must be available. A 1/2” supply line, fitted with “service” shutoff
valve is required.
5. Be sure unit will be located in a stable position & will not move unintentionally. Cabinet is equipped with
casters ... front wheels have locking brakes ... be sure they are used. Code in some jurisdictions may require
additional special anchoring of the appliance ... check local code (see Section
2.13, Restraining Device).
6. Appliance shall be installed, used & maintained in accordance with the Standard for Ventilation Control &
Fire Protection of Commercial Cooking Operations, NFPA 96.
If there are questions concerning installation procedures, contact Giles Technical Support at 800.554.4537 or email
services@gfse.com.
2.1. Appliance Location − continued
IMPORTANT!
If crate exhibited evidence of damage or mishandling, immediately inspect the unit & all accessory items.
Immediately notify the freight carrier of damages. Typically it is the purchaser’s responsibility to file & negotiate
freight damage claims.
Giles shall not be liable for damages to the unit caused by use of improper material handling equipment or
poor work practices, or for personal injuries or property damage which may be incurred during installation.
Installation expenses are the sole responsibility of purchaser, unless previous arrangements have been made
in writing.
Bekijk gratis de handleiding van Giles GGF-400, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Giles |
| Model | GGF-400 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 31766 MB |
