Ghibli & Wirbel S-Team 6 handleiding
Handleiding
Je bekijkt pagina 12 van 56
12
CONTROL PANEL
• 1 General switch
• 2 Display
• 3 Water-filling cap
• 4 Steam adjustment knob
• 5 Connector block for hose
• 6 Turbo switch
PREPARATION and START TO USE
Open the cap (3) and fill the tank with tap water.
-Note: If the water available should be
"very hard"(>20°F), It is recommended the use of 50%
demineralized water or distilled water, (this to avoid
excessive limestone formations and to be sufficiently
conductive)
ATTENTION: Do not add detergents, anti-limestone
solutions or essential oils in the water tank boiler, these
can cause irreparable damage to the boiler and circuits.
The manufacturer is not responsible for any damage
caused by improper use.
Connect the plug to a socket on an electrical
interconnection conformed to the rules of the country,
equipped with a switch and an efficient earth terminal.
START TO USE:
Turn on the main switch (1). The display (2) will light up
and indicate the temperature-pressure status of the
machine. When the machine is ready, it will display
"170". If the display lights up with 3 red dots illuminated
at the bottom, it means that the Turbo function (6) is
activated. The active Turbo function indicates that the
machine is operating at maximum power (two heating
resistors in the boiler), it can be activated / deactivated
by pressing key (6). Note: the machine keeps the Turbo
setting in memory even after switching off. When the
turbo function is not active, the machine is operating
with medium power (only one heating resistance in the
boiler – 2.2Kw). Normally the machine at maximum
power takes about 2 ÷ 3 minutes to reach the ready
state. When the machine is ready, choose the
accessory suitable for the type of use required and
connect it to the multi-function handle, using the
extension tubes, then insert the hose connector as
indicated by the white arrow in the image.
When the machine is ready, to release steam through
the handle of the flexible, press the lever button (7).
Now use the brush or accessory in the surfaces to be
cleaned.
Attention: it is recommended to perform the first
release of steam after the heating on a container for
about a minute, this is to collect any condensate water
generated in the initially cold ducts.
Attention: if you are working on delicate
surfaces or things, keep the steam jet at an
adequate distance of at least 20-40cm.
STEAM RELEASE REGULATION:
Through the regulation knob (4) placed
frontally on the machine, you can gradually adjust the
release of the steam.
END OF WATER: The acoustic and the visual
indicator of the display (2), indicates when there is no
more water inside the tank by showing "H2O", this is
why the machine will stop the steam release.
WATER SUPPLY:
Proceed as described:
Open the cap (3) and refill the tank with water (see
note PREPARATION).
Close the cap.
Push the lever button (7) of the hose handle to re-start
working. (you can hear the pump starting to work)
please wait a few seconds and then re-start your
cleaning operation with steam.
HOT WATER FUNCTION (HUMID STEAM)
To activate/deactivate the function press the button on
the handle of the hose (see picture below).
Bekijk gratis de handleiding van Ghibli & Wirbel S-Team 6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ghibli & Wirbel |
| Model | S-Team 6 |
| Categorie | Stoomreiniger |
| Taal | Nederlands |
| Grootte | 12018 MB |