Ghibli & Wirbel ROUND 45 SM 55 BC PLUS TOUCH handleiding

Boenmachine

Ghibli & Wirbel

24 pagina's

PDF beschikbaar

Handleiding

www.ghibliwirbel.com

Professional Cleaning Machines Since 1968

EN -

10.1.h - Cleaning the suction filter

(Fig. 20)

- Lift the filter with its cover (67).

- Loosen the screw (68) and remove the

filter (69).

- Wash the filter (69) in running water and

reassemble it in reverse order.

10.1.i - Replacing the fuses

(Fig. 21-22)

WARNING:

Replace the blown fuse with one with the

same amperage.

- Remove the plug (35) from the socket

(39).

- Remove the lid (70) by loosening the

screws (71) in order to access the board.

- Unscrew the knobs (72) and remove the

lid (73).

Fuse (74) - 30A

Traction protection.

Fuse (75) - 50A

General board fuse.

Fuse (76) - 75A

Battery fuse.

- Put the cover (73) back on.

- In order to replace the fuse on the posi-

tive pole of the battery, do the following:

WARNING:

Check for the recovery tank to be empty.

- Disconnect the plug (35).

- Press the button (36 Fig. 6) and lift the

tank (14 Fig. 6) until completely over-

turned, then replace the fuse (75 Fig. 6).

10.1.l - Wiper adjustment (Fig. 23)

- It is possible to adjust the height of the

wiper and adjust the incidence of the

blades on the floor.

Height adjustment

The wiper can be height adjusted using the

plates/shims placed on the wiper wheels

(82).

- Loosen the knob (81).

- Lift the support (80) and place the

plate (80a) over or under the plate (80)

according to whether you want to lift or

lower the wiper.

- Tighten the knob (81).

NOTE:

This operation must be performed on both

wheels (82) equally.

Incidence adjustment

- Lower the wiper, using the lever.

- Start the aspirator and proceed for a few

metres, then turn off the aspirator and

stop the machine.

- Check the incidence of the rubber (56)

blades.

Fig. A = too low

Fig. B = too high

Fig. C = correct position

- Use the grey knob (79) for adjustment,

turning it anticlockwise to increase the

incidence and in the other direction to de-

crease it.

10.1.m - Battery charger and digital

instrument configuration

(Fig. 24)

WARNING:

The machine leaves production with a

standard conguration for operation with

“Sonnenschein” gel batteries.

WARNING:

Disconnect the battery plug from the

socket.

- Remove the cover (70) by unscrewing

the screws (71).

Man_round-rapid_ROUND45SM-SD-Rapid_3ed_01-2019_49026700.indd 13 28/01/19 09:49

Bekijk gratis de handleiding van Ghibli & Wirbel ROUND 45 SM 55 BC PLUS TOUCH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.