Ghibli & Wirbel POWER EXTRA 7 handleiding

Stofzuiger

Ghibli & Wirbel

76 pagina's

PDF beschikbaar

Handleiding

www.ghibliwirbel.com

Professional Cleaning Machines Since 1968

EN -

Cleaning the detergent dispensing

nozzle

If you note that the detergent is not dispensed

evenly, clean the nozzle as described below:

- Remove the ring nut (37 Fig. 25).

- Remove the nozzle (38 Fig. 25) and

clean it with running water, if it is clogged

use a pin being careful not to distort the

shape of the nozzle.

- Reassemble all of the parts performing

these operations in the reverse order.

Cleaning the detergent suction filter

If you note that the detergent is not being

suctioned properly, check and clean the suc-

tion filter located inside the detergent tank.

- Using a screw driver, loosen the suction

cap (39 Fig. 26) and remove it from the

tank with the relative suction hose.

- Remove the filter (40 Fig. 26) and wash it

under running water; if it is too clogged it

should be replaced.

- Reassemble all of the parts performing

these operations in the reverse order.

Replacing the floor nozzle squeegee

(if present)

If when washing the floors the washing liquid

is not suctioned properly and the floor or car-

pet remains wet, check the condition of the

squeegee (41 Fig. 27).

If the squeegee is worn or damaged replace

it by slipping the squeegee and its bristles off

the nozzle as shown in figure 27.

Cartridge filter cleaning (if present)

- Release the levers (35 Fig. 18) and re-

move the cover (36 Fig. 19) complete

with the motor unit.

- Unscrew the knob (44 Fig. 28) and re-

move the filter (45 Fig. 28).

- Clean the filter (45 Fig. 29) with a jet of

air from the inside to the outside; it is pos-

sible to wash the filter (45 Fig. 29) in luke-

warm water and reassemble it only after

it has completely dried. If it is too dirty,

replace it.

- Reassemble everything by proceeding in

reverse order to disassembly.

Float functionality check

- Remove the cylinder head as indicated

above.

- Check that the float (46 Fig. 30) is intact

and that it slides freely in its seat.

- Reassemble everything by proceeding in

reverse order to disassembly.

SPARE PARTS

Manual nozzle (vers. auto) ...Code 7180085

Extractor M7 + strip ..............Code 6010692

Small nozzle .........................Code 6010695

Manuale PowerExtra7-8050831_4ed_03-2021.indd 5Manuale PowerExtra7-8050831_4ed_03-2021.indd 5 13/01/2022 09:47:4613/01/2022 09:47:46

Bekijk gratis de handleiding van Ghibli & Wirbel POWER EXTRA 7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.