GeoVision GV-GEBF4802 handleiding
Handleiding
Je bekijkt pagina 24 van 77
13
3.1.4.2 Snapshot Settings
Go to Config→System→Storage→Snapshot to go to the interface as shown below.
Set the format, resolution and quality of the image saved on the SD card and the snapshot
interval and quantity and the timing snapshot here.
Snapshot Quantity: The number you set here is the maximum quantity of snapshots. The
actual quantity of snapshots may be less than this number. Supposing the occurrence time of
an alarm event is less than the time of capturing pictures, the actual quantity of snapshots is
less than the set quantity of snapshots.
Timing Snapshot
Check the box for “Enable Timing Snapshot” first and set the snapshot interval and schedule.
The setup steps of schedule are the same as the schedule recording (See 3.1.4.1 Schedule
Recording Settings).
3.1.4.3 FTP Snapshot
If enabled, the system will upload snapshots to the FTP server according to the time interval.
Server Address: select the set FTP server. See the FTP configuration section for the FTP
server setting.
Bekijk gratis de handleiding van GeoVision GV-GEBF4802, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GeoVision |
| Model | GV-GEBF4802 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 13260 MB |
