GeoVision GV-GBLN4800 handleiding
Handleiding
Je bekijkt pagina 4 van 84
ii
attempt to use the product or the software, by hacking, stealing the password, or
any other means.
Electrical Safety
◼ This product is intended to be supplied by a Listed Power Unit, marked with
'Limited Power Source', 'LPS' on unit, output rated minimum 12V/2 A or POE
48V/ 350mA or AC24V (varies by models), no more than 2000m altitude of
operation and Tma=60 Deg.C.
◼ As for the modes with PoE function, the function of the ITE being investigated to
IEC 60950-1 standard is considered not likely to require connection to an
Ethernet network with outside plant routing, including campus environment and
the ITE is to be connected only to PoE networks without routing to the outside
plant.
◼ Improper handling and/or installation could run the risk of fire or electrical shock.
◼ The product must be grounded to reduce the risk of electric shock.
◼ ⚠ Warning: Wear anti-static gloves or discharge static electricity before
removing the bubble or cover of the camera.
Environment
◼ Heavy stress, violent vibration or exposure to water is not allowed during
transportation, storage and installation.
◼ Avoid aiming the camera directly towards extremely bright objects, such as, sun,
as this may damage the image sensor.
◼ Keep away from heat sources such as radiators, heat registers, stove, etc.
◼ Do not expose the product to the direct airflow from an air conditioner.
◼ Do not block any ventilation openings and ensure proper ventilation around the
camera.
◼ Do not place the device in a damp, dusty extremely hot or cold environment, or
the locations with strong electromagnetic radiation or unstable lighting.
◼ Make sure that no reflective surface (like shiny floors, mirrors, glass, lake
surfaces and so on) is too close to the camera lens, resulting in image blur.
Operation and Daily Maintenance
◼ There are no user-serviceable parts inside. Please contact the nearest service
center if the product does not work properly.
◼ Please shut down the device and then unplug the power cable before you begin
any maintenance work.
◼ ⚠ Warning: All the examination and repair work should be done by qualified
personnel.
◼ Do not touch the CMOS sensor optic component. You can use a blower to clean
the dust on the lens surface.
Bekijk gratis de handleiding van GeoVision GV-GBLN4800, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GeoVision |
| Model | GV-GBLN4800 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 12334 MB |
