Gentrax GT1200 handleiding
Handleiding
Je bekijkt pagina 12 van 16
Pull away the air cleaner housing, use the
flat screwdriver to release two plastic clips,
then the filter can now be removed.
Wash the air filter in a solution of house-
hold detergent and warm water, then rinse
it thoroughly, or wash it in a non flamma-
ble or high flash point solvent.
Allow the air filter to dry thoroughly.
MUFFLER SCREEN
AND SPARK ARRESTOR
Remove the screen cover
Remove the muffler screen
12
Use the flathead
screw driver to
pry the spark
arrester out from
the muffler
Remove the
carbon deposits
on the muffler
screen and spark
arrester using a
wire brush
Install the muffler
screen
Install the cover
Long term storage of your generator will
require some preventive procedures to guard
against deterioration.
DRAIN THE FUEL
Remove the fuel tank cap, drain the fuel
from the fuel tank.
Remove the cover, drain fuel from the
carburetor by loosening the drain screw.
ENGINE
Remove the spark plug, pour in about
15ml of SAE 10W30 or 15W40 motor oil
into the spark plug hole and reinstall the
spark plug.
Use the recoil starter to turn the engine
over several times (with engine switch off).
Pull the recoil starter until you feel
compression, then stop.
Clean exterior of the generator and apply
a rust inhibitor.
Store the generator in a dry, well-ventilated
area. Cover the generator.
1.
2.
3.
4.
5.
6.
11INVERTER GENERATOR: User Manual
1.
2.
1.
2.
3.
4.
5.
C
M
Y
CM
MY
CY
CMY
K
Page 11.ai 1 9/12/2014 7:29:33 AMPage 11.ai 1 9/12/2014 7:29:33 AM
Bekijk gratis de handleiding van Gentrax GT1200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gentrax |
| Model | GT1200 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3280 MB |
