Generac G0074090 handleiding

Handleiding

123456789101112/ 12

Afdrukken

Je bekijkt pagina 10 van 12

Installation and Operation

6 Owner’s Manual for Surge Protection Device

NOTE: SPD is listed as a Type 1 SPD and can be

installed in Type 1 applications. Field modification of

listed equipment to accommodate the installation of the

SPD in a Type 1 application may require an additional

field evaluation by an AHJ approved Field Evaluation

Body, and will be the sole responsibility of the installer.

Field modification of any Generac Service Rated

Transfer Switch for the installation of a SPD is prohibited.

Operation

1. Apply system power. LED should illuminate.

NOTE: If connected LED does not illuminate, remove

power, check connections, and test again. If LED still

does not light, contact an IASD.

2. SPD will automatically begin to protect downstream

electrical devices from damaging voltage transients.

With all phase voltages present, LED indicator reports

the status of the protection elements and is active when

all of them are intact and providing protection. Any loss of

protection is signaled when LED turns OFF.

Unit is not repairable and contains no user serviceable

parts. If unit fails, as evidenced by LED turning OFF,

contact an IASD for a replacement.

IMPORTANT NOTE: Do not use the Suppression

Circuit Status LEDs as an indication of the presence

or absence of system phase voltages.

123456789101112/ 12

Bekijk gratis de handleiding van Generac G0074090, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd