Handleiding
Je bekijkt pagina 5 van 36
49-5000913 Rev. 1 5
H. Fan Speed
The fan speed can be adjusted from Low, Medium, to
High speed when the air conditioner is in operation.
Auto adjusts the fan speed automatically to provide
ideal cooling based on the room temperature.
Press and hold the Speed button for 3 seconds to
change into Fan Only (Continuously running) mode.
NOTE: The Speed button cannot be adjusted when the
unit is in Sleep mode.
Press the Speed button to toggle among the three
speeds. The corresponding fan speed indicator will
illuminate.
I. Filter Reset Button
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the air filter (refer to Care
and Cleaning section, Page 9), place it back in the front
panel, and press the Filter Reset button. The light will
turn off.
• Mute UI sounds: Press and hold the Filter Reset Button
for 3 seconds to mute and unmute the unit
J. Swing
The louver on your portable air conditioner will open
automatically when you turn it on (do not pry it open or
push it shut).
1. When your AC is turned on, the louver will be at
position 1 (when in cool mode) or 3 (when in heat
mode).
2. Pressing the Swing button will cycle the louver
EHWZHHQ¿[HGSRVLWLRQV
• To turn on Wi-Fi: Press and hold the Swing button
for 3 seconds to turn on the Wi-Fi function.
• Refer to the “Wi-Fi Set up” section for more
information on how to connect your Portable AC to
your router and installing the HQ App.
When the air conditioner is turned on, it will automatically start in the last mode and Fan Speed setting selected.
Cool Mode
Use the Cool mode for cooling.
To set the Cool mode:
1. Press the MODE button until the Cool indicator light is
lit.
2. Press the SPEED button to set AUTO, HIGH,
MEDIUM, or LOW fan speed.
3. Press + or – to set the desired temperature.
After settings have been made, the display will be turned
off automatically after a brief period, press any button to
wake up the display.
The temperature control is used to maintain the room
temperature. The compressor will cycle on and off to keep
the room at the set level of comfort. Set the temperature
control at a lower number and the indoor air will become
cooler. Set the temperature control at a high number and
the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to Cool, it will take approximately 3 minutes for
the compressor to start and cooling to begin.
Cooling Descriptions
• For Normal Cooling – Select the Cool mode and
AUTO, HIGH, MEDIUM, or LOW fan speed with a
middle set temperature.
• For Maximum Cooling – Select the Cool mode and
HIGH fan speed with a lower set temperature.
• For Quieter & Nighttime Cooling – Select the Quiet
mode on the UI interface, device will automatically go
into LOW fan speed with a middle set temperature.
Controls
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will
automatically re-start in the settings last used after the
power is restored.
NOTE: If the Delay was set before the power outage, it
will need to be reset after power is restored.
USING THE AIR CONDITIONER
Bekijk gratis de handleiding van GE Profile PPHV10WWF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GE |
| Model | Profile PPHV10WWF |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 4342 MB |
