GE Profile PDD415PYYFS handleiding
Handleiding
Je bekijkt pagina 26 van 60
26 49-4000313 Rev 0
TROUBLESHOOTING TIPS
Troubleshooting Tips... Before you schedule service
Problem Possible Cause What To Do
Intermittent beeping Dishwasher is in pause
mode
Press Start/Pause ( ) on the control panel then close
the drawer to resume the program.
Sanitized light
flashes when the
drawer is opened at
the end of the cycle
A drawer was opened and
the cycle was interrupted
during the final rinse
Do not interrupt the cycle by opening a drawer during the
wash cycle.
The incoming water
temperature was too low
Raise the water heater temperature to between 120°F
and 150°F.
Detergent left in
dispenser
Dishes or utensils are
blocking the detergent cup
Reposition the dishes, so the water from the lower spray
arm can flush the detergent cup. See the Loading section.
Reposition the tall utensils or heavy silverware that may
be keeping the dispenser cup door from opening. See the
Loading section.
Don’t place large bowls or pots directly in front of the
detergent dispenser.
Powder detergent
not dispensed
Detergent dispenser was
wet when loaded
Clean the dispenser and ensure it is dry before adding
powder detergent.
Suds in the drawers Wrong amount of detergent See Detergent Dispensing in the Dispensers section.
Wrong detergent Use only high quality automatic dishwasher detergents to
avoid sudsing. Cascade
®
Platinum™ ActionPacs™ or Finish
®
Quantum
®
Automatic Dishwashing Detergent have
been approved for use in all GE Appliances dishwashers.
To remove suds from the dishwasher, open the drawers
and let suds dissipate.
Rinse aid setting too high Decrease the rinse aid setting. See Use a Rinse Agent
in the Dispensers section.
Rinse aid dispenser plug
not closed tightly enough
Ensure that the rinse aid dispenser plug is fully closed, with
its finger grip pointing vertically. See Use Rinse Aid in the
Dispensers section.
Rinse agent was spilled Always wipe up rinse agent spills immediately.
Water under the
drain filter
This is normal 1RDFWLRQLVQHHGHG
Drawer interior is
stained
White film on inside
surface— hard water
minerals
GE Appliances
recommends high quality rinse agents
such as Cascade
®
Platinum™ Power Dry™ Rinse Aid or
Finish
®
Jet-Dry
®
Rinse Aid
to help prevent hard water
mineral deposits from forming.
Run dishwasher with citric acid to remove mineral deposits.
Citric acid (Part number: WD35X151) can be ordered
through GE Appliances Parts. See back cover for ordering
information. Alternatively, purchase Cascade
®
Platinum™
Dishwasher Cleaner or Finish
®
Dishwasher Cleaner
and follow the directions on the label.
Some foods, like tomato
based products, may stain
the inside of the drawer
Pre-rinse dishes before placing in the drawer.
Alternatively, using the Rinse program after adding the
dishes may minimize staining.
Hard Water Living in an area with very
hard water
Increase the rinse aid setting and the amount of
detergent. See the Dispensers section.
If living in an area with very hard water, consult a
plumber on installing a household water softener.
Bekijk gratis de handleiding van GE Profile PDD415PYYFS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GE |
| Model | Profile PDD415PYYFS |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 10839 MB |
