Handleiding
Je bekijkt pagina 6 van 36
6 49-5001062 Rev. 1
USING THE AIR CONDITIONER
Using the Air Conditioner
Remote Control
ŶTo ensure proper operation, aim the remote control at
the signal receiver on the air conditioner.
ŶThe remote control signal has a range of up to 20 feet.
ŶMake sure nothing is between the air conditioner and
the remote control that could block the signal.
ŶMake sure batteries are fresh and installed correctly as
indicated on the remote control.
Eco Mode
Controls the fan.
ON—The fan will cycle on and off with the compressor.
This may result in wider variations of room temperature.
NOTE: the fan may continue to run for a short time or
may pulse intermittently after the compressor cycles off
to sample the room air.
OFF—The fan runs all the time, while the compressor
cycles on and off.
Fan Only Mode
8VHWKH)DQ2QO\0RGHDW/RZ0HGRU+LJKIDQVSHHG
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
temperature cannot be entered. The room temperature
will appear in the display.
Auto Fan Speed
Set to Auto for the fan speed to automatically set to the
speed needed to provide optimum comfort settings with
the set temperature.
If the room needs more cooling or heating, the fan
speed will automatically increase. If the room needs
less cooling or heating, the fan speed will
automatically decrease.
Control Panel Lights On/Off Feature
This air conditioner has a control panel lights on/off
feature where its lights will turn off when there is no
activity with the controls for over one minute. To wake up
the controls, press any pad on the controls and the lights
will come on to show the previous settings.
To turn this feature off, press and hold the Filter pad, on
the unit, for 5 seconds. The unit will beep to signal the
successful toggle of the feature on and off.
Cool Mode
8VHWKH&RROPRGHDWLow, Med, High or Auto Fan
6SHHGIRUFRROLQJ8VHWKHTemperature Increase
(+) /Decrease (–) pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off and
also change operating speeds to keep the room at
the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler. Set the
thermostat at a higher number and the indoor air will
become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
Do Not Operate in Freezing Outdoor Conditions
This air conditioner must not be used in ‘COOL’ or ‘ECO’
mode when the outdoor temp is below freezing (32ºF).
This air conditioner is not designed to be used in ‘HEAT’
mode when the outdoor temp is below 5ºF.
Performance of the unit will be reduced when used
outside of these temperatures (depending on the mode)
and may damage the unit.
Bekijk gratis de handleiding van GE AWGP12WWF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GE |
| Model | AWGP12WWF |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 4538 MB |
