Gaggenau DF481701F handleiding
Handleiding
Je bekijkt pagina 66 van 80
en-us Troubleshooting
66
Issue Cause and troubleshooting
All LEDs light up or
flash.
Electronics have detected a fault.
1. Press the main switch button for approx. 4seconds.
→
"Controls", Page15
The appliance is reset and restarted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Unplug the power plug or switch off the circuit
breaker in the fuse box.
‒ Wait at least 2minutes.
‒ Switch on the circuit breaker in the fuse box or plug
in the power plug.
‒ Switch on the appliance.
3. If the problem occurs again:
‒ Contact customer service.
→
"Customer Service", Page70
Water is left in the
appliance at the end of
the program.
Filter system or area under the filters is blocked.
1.
Clean the Filters →
Page51
.
2.
Clean the Drain pump →
Page69
.
Program has not yet ended.
▶ Wait until the program ends or terminate the program
with Reset.
▶
→
"Terminating the wash cycle", Page42
Appliance cannot be
switched on or
operated.
Software update is taking place.
▶ Wait until the software update has finished.
Appliance functions have failed.
1. Pull out the power cord plug or switch off the breaker.
2. Wait at least 2minutes.
3. Connect the appliance to the power supply.
4. Switch the appliance on.
Appliance does not
start.
The breaker has tripped.
▶ Check the relevant breaker.
Power cord is not inserted.
1. Check whether the power outlet is working.
2. Check whether the power cord plug is properly
inserted in the power outlet and on the rear of the
appliance.
Appliance door is not closed properly.
▶ Close the appliance door.
Bekijk gratis de handleiding van Gaggenau DF481701F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gaggenau |
| Model | DF481701F |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 7051 MB |
