Furuno SC-33 handleiding
Handleiding
Je bekijkt pagina 25 van 52
3. ADJUSTMENTS
17
3.2 [Sensor] Menu
Enter the ship’s information and installation location of the SC-33 and adjust the sensor offset val-
ues on the [Sensor] menu.
GLONASS1 You can ignore satellites of the GLONASS system by specifying the sat-
ellite number. A maximum of three satellites can be registered to be ig-
nored.
Note: When [GLONASS All] is set to [YES], the setting values for [GLON-
ASS1] to [GLONASS3] are automatically changed to “0”.
GLONASS2
GLONASS3
Galileo All Select [YES] to ignore all satellites of the Galileo system.
Galileo1 You can ignore satellites of the Galileo system by specifying the satellite
number. A maximum of three satellites can be registered to be ignored.
Note: When [Galileo All] is set to [YES], the setting values for [Galileo1]
to [Galileo3] are automatically changed to “0”.
Galileo2
Galileo3
SV ELEV
SV ELEV Adjust the elevation mask angle. This equipment does not track satellites
with an elevation angle lower than the angle set here. A higher elevation
mask angle increase the positioning accuracy, but the number of the
available satellites may be decreased and equipment may not be able to
obtain an accurate position fix
SBAS
SBAS Mode Enable/disable correction from SBAS (Satellite-based Augmentation
System).
• [On]: Enable correction from SBAS.
• [Off]: Disable correction from SBAS.
SBAS Search Select [Auto] to search automatically for SBAS satellites, or [Manual] to
manually input the SBAS satellite number.
SBAS Satellite Selection Manually input the SBAS satellite number(s) you want to use.
Note 1: This item is only available when [SBAS Search] is set to [Manu-
al].
Note 2: A satellite number entered at [Disable SBAS] will be rejected.
Disable
SBAS
SBAS All Select [YES] to ignore all SBAS satellites.
SBAS 1 You can ignore SBAS satellites by specifying the satellite number. A max-
imum of three satellites can be registered to be ignored.
Note: When [SBAS All] is set to [YES], the setting values for [SBAS 1] to
[SBAS 3] are automatically changed to “0”.
SBAS 2
SBAS 3
QZSS
ON/OFF Enable/disable the use of the QZSS system. Reboot the SC-33 to apply
the setting.
Menu item Description
Offset
HDG Offset the heading angle. When the heading angle is skewed right, enter a
negative value. When the heading angle is skewed left, enter a positive value.
Pitch Offset the roll angle.
Roll Offset the pitch angle.
Air Pressure Offset the air pressure value.
Menu item Description
Bekijk gratis de handleiding van Furuno SC-33, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | SC-33 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9007 MB |
